If you have removed the 2 screws in side the bed at the tailgate and having problems getting the light cover off. The best way that I have found is to spray some WD40 up in on the 2 rubber posts that are inside behind the light. This should make it just pop right off.
How to remove bed rails from a dodge truck
You slowly remove it
Remove the ligth assy and unscrew it from the rear.
You must look for a circular cover in the truck of the car on the other side of the break light. Remove the cover, unscrew the screw, don't drop the screw into the space. Then remove the outside light carriage.
You have to unbolt it from the frame that attaches to the hood of the truck.
Why would my 1984 Dodge pick up truck stall at the light when I stop
Easy 4 to 6 bolts.
From behind the light bezel (under the truck) quarter turn and remove the lamp holder. Replace with an "893" type bulb
dodge truck beds bolt on from the bottom, you will need to remove the rear bumper assembly and the fuel filler neck from the side of the bed too. then just call a few friends to help lift.
Open the tail gate. Then look at the inside of the truck where the tail gate cables are and you will see 2 small screews, Remove them and the light will come out of the truck body.
remove the 4 10mm nuts under the plastic cover in the truck. the complete light assembly will then come off the car. then just twist socket to remove the bulb
The wait to start light on a 92 Dodge Diesel truck can be caused by a lack of fuel to the engine. It can also be caused by a wiring problem.
A fuse diagram, for your 1994 Dodge ram 1500 pickup truck, can be found on the inside cover of the fuse box. The diagram can also be obtained from most Dodge dealerships.
the tail light is screwed in from the inside of the bed of the truck
Replace the burnt out light bulb
Do you have to remove the battery and battery holder?la
where can you find a website for free diagram of tail light wiring on a 1994 dodge 1500 truck?
You will need to remove the water lines from your 1995 Dodge Dakota truck heater core. Remove the heater core retaining bolts. Reverse the process to install the new heater core.
On the "b" series in a Dodge truck it is either on the driver side of the timing cover, the side of the valve cover, or the top rear of the valve cover.
You have to remove the center of the axle plate and the axle to remove the brake hub.
A scan tool is required.
That requires a scan tool.
lift hood look at back of light threr is a twist lock simply twist to remove replace bulb and reinstall
remove the two light lens be careful not to break them. then remove the two torx screws behind the lens. give a slight pull down on the front of the console to remove the two clips and you are done.
i have a 2002 dodge truck and this is how it is done; 1) lower the tailgate 2) There are 2 "torx" screws holding the housing on, remove them 3) The wire that leads to the bulb mount must be removed, there is a red lock on it, slide the lock to the left (from the top) and then remove the taillight assembly. 4) there are 4 Phillips head screws holding the light bulb mount, remove them and pull the mount from the lens assembly 5) replace bulbs 6) installation is the reverse of the dis-assembly. Have fun !!!