Car Stereos and Speakers
Dodge Dynasty
Chevy Avalanche
1982-1994 Chevy Cavaliers
How To

How to remove rear stock speakers from a 1992 Dodge Dynasty?

616263

Top Answer
User Avatar
Wiki User
2015-07-16 19:22:05
2015-07-16 19:22:05

There are two bolts on the front edge of the bottom of the seat. One per side, take those out then slide out the bottom seat cushion. Remove the two bolts holding on the back of the seat. It should lift out. Then one or two screws should hold on the back deck.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

6/9 in the front and 5.25 in the rear

User Avatar

6x9 in the front doors, 5.25" in the rear doors. The stock infinity speakers are problematic.

User Avatar

i believe they are 6.25" all the way around

User Avatar

For a 1998 Dodge Ram 1500 extended cab, there are two different sizes of speakers. The front speakers are 6x9 and the rear are 5-1/4.

User Avatar

The speakers in a 2003 Dodge Intrepid measure 6 3/4 inches in the front door. The rear door deck speakers measure 6 3/4 inches and the front dash speakers measure 3 1/2 inches.

User Avatar

Dodge Spirit and Caravan are the only ones I can think of as they carry the same wiring and everything as a Dynasty would.

User Avatar

well, most stock speakers are usually around 4" ( 4 inches ) so i advise you to buy 4" speakers and they can get pretty powerfull they can reach over 160W of power.

User Avatar

I have a 1993 dodge shadow and I thought it was complicated to change my speakers to but, it really isnt. The rear spearker have that plug of wires all you need to do is cut the wires and use the inner two wires for any aftermarket spaekers. The front speakers are a pain to get to since you have to mess with the door clips and pull the pannal off but the speaker wires are self explanitory. Make sure to electric tape the other wire so is not to have a short. Any other questions on how to get to or remove or install spearker componets e-mail me @ Allicedout19@yahoo.com

User Avatar

assuming you plan to change the speakers on the frond doors, remove the bottom screws on the door frame (they should be facing up), then remove the bottom half of the door panel. Unscrew the stock speakers and replace them with new ones. Then put the door frame back on the door.

User Avatar

1993 Dodge Shadow stock in reverce.

User Avatar

Remove the side panels closest to the doors and unscrew the top screws on the dash. Once you remove it will be easy to take out the stock speakers and replace them. I replaced mine with a pair of Alpine Type S SPS-600 Speakers, this makes a huge difference. Good luck!

User Avatar

As far as the watts go i am not for sure. As for the diameter of the speakers they are 5 1/4" or 5.25"

User Avatar

You have to remove the door panel. After you will see the speaker which sits in 4 screws. Remove the screws disconnect the speaker and in the reverse order for your new speaker. Keep in mind, whatever new speakers you get, the stock amp on this vehicle has a low pass filter to the door speakers (and a high pass filter to the dash) so they won't deliver any highs.

User Avatar

the size of the speakers are 6.5" round

User Avatar

According to sonicelectronics.com database both front and rear stock speakers are 6"x8"

User Avatar

they dont ship stock with rear speakers.

User Avatar

The front speakers is 4x6, and the rear speakers is 6x9.

User Avatar

the 2005 Dodge Cummins stock horsepower is 325


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.