I own a 1996 bonneville. The tensioner bolt is a reverse threaded bolt, (tighten to loosen). Hope this helps. DCC
You will need to remove the front engine cover, on your 1997 Pontiac Bonneville, in order to change the supercharger belt. Loosen the tensioner pulley to remove the belt.
how do you remove the turn signal assembly on a 1989 Pontiac Bonneville
To change the serpentine belt on a 2003 Pontiac Bonneville, loosen the tensioner pulley and remove the old belt. The tensioner pulley is the wheel in the belt system that has a bolt through the middle in a slot that can be adjusted. Put the new belt on and tighten up the pulley.
what tools do i need to remove the wheel cylinder on a 1993 pontiac bonneville
I have to jump start my Pontiac Bonneville 1988 everyday I drive it why is that.
How to remove left inner door panel of a Pontiac Bonneville 1996
If it is not serpentine - loosen the alternator mounting bolts and it should pivot allowing you to remove and replace If serpenting - relieve pressure on the tensioner and belt should be able to be removed
You can remove your 1997 Pontiac Bonneville ignition switch by removing the retaining ring at the top of the ignition switch. The ignition switch will slide out.
Before you remove the evaporator core from a 1998 Pontiac Bonneville you need to have the air pressure discharged. You will then need to remove the AC unit. You will need to remove some screws before you can remove the evaporator.
Remove the serpentine belt. Tensioner is below Alternator. Remove the three mounting bolts on the tensioner baracket assembly. Replace entire unit.
Pontiac Bonneville was created in 1957.
The PCV valve on a 2002 Pontiac Bonneville is located on the back of the in take manifold, however to get to the PCV valve you will need to remove the valve cover.
you dont! it has to be in the off position
Begin by removing the decorative cover from your 2001 Pontiac Bonneville radio. Remove the radio retaining screws. Slide the radio out and remove the wiring harness and the antenna cable.
do know where the horns on Pontiac Bonneville 2000 is do know where the horns on Pontiac Bonneville 2000 is
bolt pattern for 1979 Pontiac Bonneville
There is a side pan which is sometimes accesable if you remove the wheel.
show me where the starter relay is are on a 2000 Pontiac Bonneville
diagram for serpentine belt on 1996 Pontiac Bonneville se
where is a knock sensor located on a 96 Pontiac Bonneville
1992 Pontiac Bonneville it will turn over but will not strat.
How to fix a gas hand on a 2001 Pontiac Bonneville
The bolt has left-hand threads, and requires a lot of torque. Turn counter-clock-wise to loosen/remove the serpentine belt, then use a cheater-bar on your wrench to loosen the pulley-bolt (turning clock-wise).
underneath the dashboard on the passenger side.
Begin by training the water from your 1997 Pontiac Bonneville cooling system. Remove the heater core water supply hoses. Remove the heater core retaining bolts. Reverse the process to install the new heater core.