Want this question answered?
The 1991 Mercury Sable ignition switch is held in place with a retaining ring. Loosen the retaining ring. Pull the ignition switch out. Remove the wiring harness from the rear of the ignition switch. Reverse the process to install the new ignition switch.
How to remove ignition switch on a 91 Mazda Navajo
Remove the retaining ring at the top of your 1991 Acura Legend ignition switch. The ignition switch cylinder will slide out. Remove the wiring harness from the end of the ignition cylinder. Reverse the process to install your new ignition switch cylinder.
The entire ignition switch assembly will unholy from the steering column. The key is required to remove the cylinder from the switch.
Never mind figured it out
Remove steering wheel and signal switch
n ignition switch on a 1991 Chevrolet astro vanAnswern ignition switch on a 1991 Chevrolet astro van
drop your steering column... not exactly sure where it is from there but that is the location of it.
Ok so you have to go where the ignition switch is at on the 1991 cougar. Next, You have to take the old one out. Last, you have to put the new one in.
changing the ignition switchfirst you have to take the steering wheel off.then you have to to have a tool called a steering wheel lock plate remocer/installer to remove the plate under the wheel .then you need to remove the turn signal switch (there is four screws holding it in , remember how you take it off )after that you have a little torx screw that you remove so you can slide the ignition out of the column .use the same directions in reverse to put the system back together with the new ignition switch
No.
remove the plastic surround. put the key in the ignition and turn to accessories . look at the end of the ignition switch cylinder for a small pin that will depress. when depressed the ignition will slide out. the new one goes in the same way . no tools needed except for the plastics part.