answersLogoWhite
Oxygen Sensors
Chevy Silverado
Subaru Outback
How To

How to replace 1999 Subaru Outback oxygen sensor?

242526

Top Answer
User Avatar
Wiki User
Answered 2007-03-21 22:01:18

Unplug sensor--- sometimes you can get a wrench on the sensor if not you will have to purchase the special socket.Genuine parts are often high so you can get the sensor at an auto store directions are included with the sensor as how to attach the pigtail and ude the heat shrink tubing suppied

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Your Answer

Related Questions


Where is the bank2 sensor 1 located on a 2001 subaru outback 3.0


I just purchased new catalytic converters for my 1999 Subaru Legacy Outback. There are three ports for oxygen sensors. They appear to be on the top of the converters. I just purchased new catalytic converters for my 1999 Subaru Legacy Outback. There are three ports for oxygen sensors. They appear to be on the top of the converters.



Throttle position sensor on this vehicle is held on by two screws. It's a 10 minute job.


there are two. both along the exhaust under the car. one just before the catalytic converter and one just after.


When a Subaru has a faulty O2 sensor the fuel management is out of whack.


Directly below the alternator on the block.


P1137: Front O2(oxygen) aka A/F(air/fuel) Sensor Circuit Range/Performance Problem.


To replace the oxygen sensor on a Honda Odyssey, first unscrew the sensor. Then use a 22 mm socket or 7/8 inch wrench to replace the oxygen sensor.



The code 32 for a Subaru vehicle is for the coolant sensor or the oxygen circuit.



It is located on the engine block drivers side.


the knock sensor in on the drivers side of the block toward the rear, and it's under the intake manifold.


The 2002 VW oxygen sensor is quite simple to replace. Remove the wiring harness. The oxygen sensor will simply pull out.


the oxygen sensor is located between the fist and second muffler. you will need to disconnect the sensor and it will then unscrew out of the exhaust pipe. I just did this on my H6 and I also needed to replace the air mix sensors on each side of the motor. they look just like oxy sensors and my need to be replaced as well. they are located on either side of the headers. the best way to get at them is from under the hood. you will also have to disconnect these sensors from the top and then unscrew them from the headers on each side.


To replace the oxygen sensor disconnect the oxygen sensor electrical connector. Use an oxygen sensor socket to remove the sensor. spray the sensor with penetration oil if it is difficult to loosen. install in reverse.


An Oxygen sensor does not reset. You have to replace them and yes they are expensive.


No. do you mean the front or rear o2? The front might be an A/F sensor. Big difference. But no, there isn't.


You bring it to a service station and tell them to replace the oxygen sensor.


how do you replace oxygen sensor of 2001 bmw 318 ci es


Absolutely. Not just on Subaru but every car built that has an oxygen sensor. And they all do.


Probably referring to a heated oxygen sensor.


http://www.lovehorsepower.com/SubaruDocs/CoolantTempSensor.htmlits a 1995 but same thing


you cant there is an electronic throttle position sensor that controls idle may be bad



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.