My Montana is a 2005; but I believe the set process is the same: 1. Some vans may have a hard plastic "protector" located at the corner. If that is the case, remove it by pushing it up by its clips. 2. You have to remove the round bar. There are two bolts in front and one in the back by hood hinge. The round bar slides out of the relay box. 3. Remove the wire connecting to the relay box to the battery by removing the holding nut. 4. Lay the relay box over - towards the motor. 5. Remove the hold-down bolt located on the backside of the battery at the bottom. 6. Remove the batter posts bolts. 7. Remove old battery. 8. Put new one in and reverse the above steps. Good Job! .
2001 Pontiac Montana?
it is a 2001 Pontiac Montana that has broken three bealts so far I need to know what pully I will need to replace?
How much refrigerant is needed recharge ac on a 2001 Pontiac montana
2001 Montana has an electronic transaxle. There is no vacuum modulator. The 2001 Montana has an electronically controlled transaxle. There is no vacuum modulator.
yes it has one
No
Pick up the Haynes repair manual, it goes through the process step by step. I found it through Amazon.com. I am about to replace the one on my 2001 Pontiac Montana. Good Luck
under the antifreeze compartment
sounds like the fuel sensor inthe fuel tank which means removing tank to replace
There is only one fuel pump fuse on a 2001 Pontiac Montana. It can be found in the engine compartment near the firewall at the rear of the compartment.
The 2001 Pontiac Montana block heater cable can be found in the front of the vehicle. You can access the block heater cable through the front grill.
There are three of them, and they are all located in the fuse/relay box on top of the battery. The inside of the box cover is labeled to indicate their locations.