First you pop the trunk, then on the side of the car where the replacement is there will be a carpet material with a few plastic nuts you can unscrew with your finger tips, unscrew and pull the carpet away then you will see the back of the light where the bulb is, grab and twist left gently and pull out the light then pull the bulb out and replace the same way it was put together!
It is a Pontiac Aztek. Light a match and get some marshmallows.
IT is in the sun
Yes, they are direct bolt in
if your talking about the tail light you have to go through the trunk move carpet and side panel there are 5 (I think 0 wing nuts to remove the whole tail light assy thyen you'll see the individual sockets for each light
3 big plastic wing nuts hold the tail light assembly in the body. remove those and the tail light can be removed to gain access to the bulbs.
This is because the tail light bulb has a different element in the bulb. Just replace the bulb and that will fix the problem.
Read more: http://wiki.answers.com/How_do_you_replace_the_tail_light_in_a_2000_pontiac_sunfire#ixzz1Nur0XSlq
There should be a panal inside the trunk if you remove that you can take the nuts off and remove the rear tail light giving you access to the bulb.
Remove carpet inside trunk that covers tail ligh assembly, then unbolt tail light assembly, remove the assembly and bulb fixture of the bulb you want to replace, replace bulb and re-install in reverse order.
you don't replace the tail light you just replace the bulb in it
Open the tub of the turn signal housing and uncrew the 2 scews holding it and pull out the whole housing .
On a 2012 toyota Highlander, How do you replace tail light Assembly