answersLogoWhite

0


Best Answer

my husband just did so. the pulley is part of the air condition compressor, so you have to replace the whole part that's connected to the pulley, you can'tjust replace the pulley it self, and going to the junk yard for these partsis very cheap and the way to go.

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How to replace air conditioner pulley on 93 Ford Thunderbird?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you replace the serpentine belt on a 1997 Ford Thunderbird?

Remove your idler pulley first. it is the pulley right next to the alternator.


How do you replace a pulley on a 1993 Ford Taurus gl?

Which pulley?


Where does the trunk drain hoses go on a 1965 Ford Thunderbird?

How do you replace the trunk drain hoses on a 1965 thunderbird.


When do you replace a pulley in Ford Explorers?

When it goes bad


How do you replace a starter for a 94 Ford Thunderbird?

go check in iraq, you commie. comprendo?


How do you repair seatbelt on a 1990 Ford Thunderbird?

Dont repair...just replace it for your safety!


How do you replace the fuel pump on a 1992 ford thunderbird?

Remove fuel tank for access


How do you unlock A Ford Thunderbird?

When i bought my thunderbird the key to the ignition didnt fit the door locks so i had to replace the locks. That might be the best answer. :]


How do you replace the belt tensioner on a 3.8L Ford Thunderbird?

On my Taurus 3.0 engine, I used a wrench on the pulley bolt, and a pry bar to remove tension, allowing me to remove the belt. Then I used a star pattern socket to remove the nut.


How do you put freon in a 1994 Ford Thunderbird Lxcoupe?

1994 TBird has an R134 system. You can buy charge kits at any auto parts store. How do you put freon in a 1994 Ford Thunderbird Lx coupe so that the air conditioner can work?


Replacing a lock cylinder for a 94 Ford Thunderbird?

You can replace the locking cylinder, on your 1994 Ford Thunderbird, by removing the inside door panel. The locking mechanism will be visible with the door panel removed.


How do you replace the serpentine belt on a 1989 Ford Thunderbird 3.8L?

you need a serpentine belt remover. Its $20 at autozone...The pulley on the bottom left will pull up if you use the tool..its the small pulley on the bottom left...very easy with the right tool....takes three hours without it:] and a lot of cussing...