Bumpers
Honda CR-V
Honda Civic EX
DIY Projects
How To

How to replace the fender and bumper?

111213

Top Answer
User Avatar
Wiki User
2009-01-14 23:24:18
2009-01-14 23:24:18

a albino terd like n.t.c. ha hahaaa

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

You can purchase a new aftermarket fender for aprox. $50.00 & front bumper for $80.00. The rear bumper for aprox. $ 175.00. I recently bought these.

User Avatar

Fender is on the side of the car, over the wheel. Bumper is on the front below the grill running from side to side.

User Avatar

remove headlight there is 2 bolts there ,remove enter fender there is one nut that bolts the bumper to the fender,there is two bolts at the bottom of the fender next to the door.then one bolt in the middle of fender next to the door. then you got the bolts on top of fender under hood

User Avatar

You have to pull down the inner fender skirts to gain access to the fasteners of the front bumper cover. Once you've got the front bumper cover pulled away from the headlamp assembly then unfasten the assembly then it can pulled out without the bumper or front of the fender being in the way.

User Avatar

On a Saturn there are metal clips that hold the bumper to the fender. One of these fell off of my 2001 SL1. It was fairly easy to replace, but should never have happened. It just simply clips in place once you line the bumper with the fender. I think these clips are in place all the way around the bumper. It was the passenger's side of mine that came off.

User Avatar

Yes. The bed of a pickup truck is a separate structure. It can be unbolted and changed like a fender or a bumper.

User Avatar

remove grill,remove bumper,unbolt fender bracket off bumper bracket,take off splash pan in between door and fender,take out fender bolts,don't forget bolts on bottom of fender.there is a bolt under the fender ,back by the door at the top.pull fender off.good luck.

User Avatar

Remove the headlights, remove the hood and you probably need to remove the bumper. All along the fender should be bolts that secure the fender to the van. There will probably be about 6 on top, 2 or 3 on the bottom and a few along the side.

User Avatar

You have to take out the bumper. Just take out the screws that are in the fender, take out the plastic cover that it is under the car that is attached to the bumper, take out the clips of the plastic grille with the Honda logo and pull the bumper. Don't apply to much force. When the bumper is out you will see the other bolts to remove the headlight.

User Avatar

Getting the alignment(gap) right is the hardest. Just need to remove the headlight, raise the hood unbolt the fender bolts. The fender bolts near the door jam, You get access with the door open. You might need to remove the bumper to remove.

User Avatar

To replace a Pontiac Grand Am bumper cover, start by taking out either the three bolts on the side of the fender or in front of the wheels. Remove the top pushpins to remove the cover. Push back the two pins for each headlight, and pull them up. Unplug the lights. Then, get the replacement bumper, and snap it into place like the previous one.

User Avatar

how to replace rear bumper brackets on a 2002 Nissan sentra

User Avatar

remove bumper, replace with new one.....easy huh ?

User Avatar

How do you replace a 1996 Grand Prix front bumper?

User Avatar

It can cost $50 to $300 to replace a front bumper of this car. This depends on where the part is bought and where the work is done to replace the bumper.

User Avatar

Take the bumper-cover off first- in this order: wheel-well screw, underneath the chassis screws, then the bumper retainer bar in front of the hood latch. Then crack the bolts in the wheel well which connect the fender to the body. It might be cheaper to get a body shop to repair a fender than a relacement, unless youre going for a wide body thing.

User Avatar

if the bumper protector is damaged yes, or else the cover will have no suppot

User Avatar

ok first remove all of the screws from the inner fender walls that connect the inner fender walls to the fenders remove the factory mud flaps from the fenders than un bolt the bumper from the top an bottom than remove all fender bolts to remove both fenders as the right and left sides are of the bumper are connected to the fenders from the inside you should have a buddy to assist you as not to scratch or damage anything in the process be sure you line up the fender straight with the new bumper and do not bend anything the fenders are very thin and bend easily take your time this could take you a coupple days . good luck rob g

User Avatar

The horn is located behind the right side inner fender just behind the bumper, one bolt holds the horn in place. Remove the plastic plugs and pull the inner fender plastic aside then you can get to the horn, this in on a 1995 sportage.

User Avatar

How do you replace passenger side fender on a 1998 pontiac bonneville se

User Avatar

passenger fender right behind the front bumper cover

User Avatar

right front wheel well , between inner fender and bumper.

User Avatar

how to remove a fender on 99 taurus


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.