depending on if your are replacing it or just putting in a bulb. usually to replace the bulb you would have to dig your hand down behing the light and find out high beam or low beam and remove it. but if you are replacing it you will need some small tools to remove the light bcuz it is attached to the turn signal and mount to the radiator frame.
You will need to change the brake light switch. The brake light switch can be found below the dashboard on the drivers side.
Replace bulbs Check the fuse Check the stop light switch
head gasket blown. reface the cylinder head and replace gasket. that should fix the problem
We had a light alignment problem on our 2007 S40 and they could not adjust due to the design of the head lights... The fix was to replace the left 2007 S40 head light with a 2008 S40 head light....
You need to have it checked for codes. If you fix the cause of the codes the light will stay off.
1997 dodge ram 1500 tried head light switch did not work.head lights and running lights do not work at the same time.
Came up to a stop light and when the light changed the car would not move.
If there is no light at all in whole dash. first check the fuse second check the headlight control switch.
it is under the front passeneger carpet it is white. I recommend going to pep boys and buuy a chiltons manual and it is quite informative. My son is learning to fix his 91 legend with this book. Good luck
When the check engine light is on, the computer sets a fault code. Most auto parts stores will check this code for free and tell you how to fix it.
replace the head light switch
does nanotechnology ( head gasket and block repair) fix blowen head gasket
More than likely you have a blown head gasket. Replace the gasket and check the head for cracks or if it is warped. Do not continue to drive.
You replace it you do not fix it.
If you remove the head then of course you replace the head gasket.Where can you get sodium silicate to fix a blown head gasket?Know that adding sodium silicate to an engine is only a temporary fix for a blown head gasket and will not permantly fix the problem. The only permanent fix is to replace the head gasket. I would never add any head gasket fix material to any engine.
In Coldplay's "Fix You" video, the lead singer swings a lightbulb around his head on stage at 2:45
Replace the head gasket is the only fix.
You can't fix a cracked head unless you can weld. it must be replaced with a new head.
replace the head light switch. the coils in the switch get hot n turn off the lights.
you do not fix the light. you fix what ever caused the light to come on. so the lenght of time depends on the cause for the light to go on on the first place.
If the lightbulb itself is burnt out on a 1991 Mercury Cougar then just replace the light. If it is the wiring that is the problem then find the burnt wires and cut them. Replace them with new wiring.
The only fix is to remove the head and replace the gasket.
For Temporary Fix, By A Rocker Switch From Auto Parts Store. Pull Your Head Light Switch Out Of The Dash Wire In The Rocker Switch. Will Have To Find Wiring Diagram Or Chiltons Book For Wiring Schematic For That Year Of Vehicle. Only Temp Fix, Should Replace With Stock Switch For That Vehicle.
How do i fix the eml light on in my 325i BMW