0
If a 90 Volvo 240 has voltage to the wiper motor in all positions and a good ground why doesn't it work even after replacing it?
Wiki User
∙ 18y ago
Was the motor replaced by a new or known good used one?
Wiki User
∙ 18y ago
Add your answer:
Earn +20 pts
Does voltage on ground mean open ground?
Voltage on ground can mean an open ground. It can also mean (high) current on ground, due to a ground fault such as reversed neutral and ground.
Is transmission voltage a phase to phase voltage or a phase to ground voltage?
Phase to Phase voltageCorrection to the above answer:There is no such thing as a 'phase-to-phase' or 'phase-to-ground' voltage. The correct terms are 'line-to-line' (or 'line voltage') and 'line-to-ground' (or 'phase voltage'). Transmission-line voltages are line-to-line (or 'line') voltages.
Why would a 2001 Ford Escape XLS be hard to start when it rains?
try replacing your spark plug wires, as they get old damp conditions will allow the spark to "ground out" sending your voltage back to ground instead of to your spark plugs where it belongs. good luck
What are the 3 wires on a map sensor for a 5.7 hemi?
5 volt supply, sensor ground and signal voltage.5 volt supply, sensor ground and signal voltage.
What are the differences between voltage and potential difference?
Voltage is the potential difference to the ground. By convention, ground potential is zero volt.The above answer is incorrect. 'Voltage', by definition, is potential difference. It has nothing to do with being measured with respect to ground -in fact potential difference (voltage) cannot be measured with respect to anything.
What is the voltage to ground of 13800 volts line to line?
On a three phase system with a line to line voltage of 13800, a wye connection will give you a voltage of, 13800/1.73 = 7977 volts to ground.
Phase to ground voltage?
There is such a thing, what is your question?
Why neutral ground voltage is 120v sometime 0v?
There should be no voltage on the neutral wire to ground. This is a serious situation. Call a qualified electrician to check this out.
Why do you have voltage to ground but not voltage phase to phase?
There is phase to phase voltage in 3 phase system.AnswerYou don't get voltage 'phase-to-phase'; it's 'line-to-line'!
What cause excessive ripple voltage from a power supply.?
I think the cause of ripple voltage would be from a bad ground or capacitve voltage.
Is the drain wire in medium to high voltage applications considered a neutral or ground?
ground
The difference between short to a voltage circuit and short to a ground circuit?
A short circuit is an abnormal connection between two nodes intended to be at different voltages. A voltage circuit is caused intentionally for the purpose of voltage sensing. A ground circuit occurs between a phase and the ground.
