0
If the wall of an electrical equipment vault are made of hollow concrete block what is the minimum thickness of the wall?
Wiki User
∙ 12y ago
An electrician would not normally construct a building or an electrical equipment vault. Not specified in the Code (means can be 6 in., 8 in., 12 in.)
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How far does an electrical panel have to be from a side wall?
Working space around electrical equipment shall be minimum: 30" wide and 36" deep and 6'-6" high. The panel door must be able to open at a 90 degrees angle.
What is the minimum age to attend a class for electrical installation training?
To be qualified for electrical installation training in the US, you must be at least 18 years or older.
What is the minimum size wire allowed for a parallel run?
The minimum size wire that can be paralleled together stated in the electrical code book is a #3 copper conductor.
What is the minimum allowable side distance from 480 volt electrical panel and emergency safety shower?
30 inches
Clearance around an electrical panel?
The National Electric Code requires min. 3'0" there are several rules defined in section 110.26 of the NEC; for 600 volts or less it is: * left to right the minimum clearance is 30" or the width of the equipment, whichever is larger * in height, there should be 6' 6'' minimum height to stand in front of the equipment (exception for dwelling units for panels 200 amps or less) * the depth in front of the equipment varies depending on the voltage and surfaces of the opposite wall behind you: if the voltage is 150 volts to ground or less the depth of clearance is 30": as stated above; if the voltage is higher it depends of whether the opposite wall is insulated or not: if insulated the depth is 3' 6", if not insulated (such as cement block) the depth is 48"I refer to these rules as the "refrigerator rule": the clearance in front of the equipment in question requires a dedicated clear space roughly the size of a large refrigerator
What is the minimum thickness of mass concrete?
80mm
What should the thickness of a concrete foundation for your house?
Minimum of 6 inches....also may depend on where you live
What is the minimum thickness concrete can be poured?
any thickness of concrete can be poured however if it contains an aggregate you would be limited to the diameter of the stone. you may also replace the water component with a latex additive that will substantially improve the strength.
The minimum distance between the declination station and such objects as power lines and electrical equipment is?
Power lines and electronic equipment: 150m
What is the minimum brake rotor thickness on my Ford Explorer and what is the thickness when new?
2004 ford explorer minimum rotor thickness
What is the minimum rotor thickness for 2002 dodge Dakota front?
Minimum thickness is .8898 in.
How many yards of concrete do you need for a 500 sf patio?
If you use a standard 4-inch thickness you will need a minimum of 6.17 cubic yards.
What is the minimum thickness of brake rotors?
It is the safe and legal minimum thickness allowed for a brake rotor.
What is the minimum thickness of the front brake rotors on a 1999 Isuzu Trooper?
Minimum disc thickness vented front 24.6mm .Minimum disc thickness rear 16.6mm. min pad thickness front & rear 1mm
How much Concrete do you need for a 22 squared slab?
A 22x22 foot slab at a 4-inch thickness/depth requires a minimum of 6 cubic yards.
What is the minimum brake rotor thickness for a 2001 Pontiac grand am gt?
The 2001 Pontiac Grand Am minimum brake rotor thickness is .075. The minimum brake rotor thickness is a standard minimum. Certified mechanics cannot use the brake rotor when the thickness drops below this level.
What is the minimum disc rotor thickness 03 ford escape?
The minimum thickness should be cast somewhere on the rotor.
