0
If the windshield wipers don't work and the fuse has been replaced twice now but it keeps getting burnt out what is wrong?
Wiki User
∙ 16y ago
try replacing the windshield wiper moter, and check for damaged wireing that could be causeing a short and blowing fuses.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
Why might windshield wipers stop working?
your windshield wiper motor might burnt out or a fuse might burnt out
Why would my windshield wipers and power locks stop working on my 1992 Jeep Laredo?
burnt fuses
Why did the windshield wipers stop working on cavalier?
either your motor burnt out or you have a faulty switch that turns them on. Or check the fuse
Your windshield wipers will not turn off and the horn will not honk on your 2000 Dodge Stratus?
You probably have a short in your electrical system. Also the fuse may be burnt out on the horn.
What causes the windshield wipers delay option not to work AND the wipers to stop in place when you turn the switch to the off position?
you will need to replace the wiper motor. there is a SET OF CONTACTS IN THE ASSEMBLY THAT STAYS TOGETHER TIL IN THE STORE POSITION[BOTTOM OF WINDSHIELD]. THIS IS EITHER BROKEN OR BURNT OFF, THUS DISABLING BOTH ACTIONS
Why does your rear windshield wiper not work on a 2003 Chevrolet Venture?
There are a few reasons why a windshield will stop working. The fuse could be blown, the motor could have died, the wiring could be burnt, or it may not be getting enough electricity.
What if the windshield wipers stop working?
There are lots of possibilities: Check the fuse and make sure it is good. You may have a burnt out the motor. You may have simply 'stripped' the wiper motor connection. There is a bolt on that connects the wiper to the motor. Tightening it may be enough to get it taken care of.
Ballast smells burnt what to do?
A ballast that smells burnt is going bad. The ballast will have to be replaced to fix the problem.
1993 buick lesabre wipers only work at low speed why?
The resitor is probably burnt out on the high mode
Why won't intermittent wiper control wo rk on your 93 jeep grand Cherokee?
in the kick panel on the drivers side forward of the door there is a control box velcroed to the inside. this is the intermittent wiper control box if your wipers dont park or they wont spray windshield fluid this box is more likely the cause. a quick way to test this is to disconnect the box on both ends. then connect the two plugs together. your wipers will work in the low and high position only but they will park when shut off, also the windshield waasher fluid should spray again too. what you need to do is replace that control box, or if you think you can fix it open it up and look for the burnt solder strip on the board. I fixed mine three times this winter alone and all i used was stranded wire copper wire pieces looped around the broken solder strips
How do you fix a burnt valve?
Remove the head and have the valve reseated or replaced.
How do you disassemble the dashboard on 1996 Kia Sephia?
Park it in the sun. Ours had burnt from the sun and is now curling backward away from the windshield!
