98 accord does not have a rear axle- just spindle/hub/bearing
The rear axle bearings on a Honda 300ex are replaced by first removing the rear wheel. The bearing cap and retaining ring are then removed and the bearing is then pulled from its housing.
In order to dissemble the rear axle on a 2000 Honda TRX 300 first determine if it is inner or outer joint. You then remove the retaining ring behind the boot to access the axle.
Remove rear axle cover, oil will drain out, reseal and install cover, fill fluid.Remove rear axle cover, oil will drain out, reseal and install cover, fill fluid.
how hard is it to replace a rear wheel bearing 1999 Honda crv. this crv does not have rear axle's in it. thank you
need free picture diagram for 1997 honda four wheeler rear end
101 ft/lbs
No. They bolt up differently and have different bearing and seal kits. Also the axle is not as thick as a 300 axle.
Front axle = 55 lbf-ft. Pinch bolts = 9 lbf-ft. Rear axle = 80 lbf-ft.
yes they all have the same rear ends
There's only one axle...not a left and right. Buy a Honda service manual before you tare it up.
There is a complete walk through in the related links section.