It's the same thing. To make it even more confusing... your power source is 220v.
There should be no problem at all.
it will not run
230 Volt
In the United States most homes are wired with both 240V AND 120 V. The question becomes, why, in India is there ONLY 230 V? Another difference; in The US and Canada, we use 60 Hz, while in most of Europe they use 50 Hz.
Your electrician is correct on this. However, the pump is designed for 230V and will use less electricity, thus saving money if wired for 230V. Yeah, if you have to rewire for 230 V then it would be more expensive until your savings had consumed or offset the expense.
Yes, it can be and there is no problem at all Because most of the electrical appliances are made to work on 220v - 240v so it can also be plugged into a 240v outlet.
Dewalt by far.Have used a stand up for 8 years with no problems.
Yes it will. If you consider the variances in voltage that occur during the course of a day, at 230v rating you may be getting 240v coming in anyway. The 10v difference is less than 5% and any appliance worth it's salt will handle this no problem.
Yes, electronic products need to work over a range of voltages as the mains is not maintained at exactly 240V or 230V. Typically they have a range of at least 10% and normally much more. So it should work down to at least 216V.
Yes, you can use a 230 volt device on a 240 volt supply.
its ok..i found out that it can be done, as long as its not turned up to use more than 130amp.:)
One word: KABOOM.
Probably because years ago the voltage supply in most residential applications was 110/220V. It was increased to 120/240V to increase efficiency. If you use a heater element rated at 230V in a 240V application you will be "overvolting" it and will probably reduce the life of the element. If using an element rated at 240V in a 230V application you will be "undervolting" it and it will probably not get quite as warm as it is designed to.
There are plenty of models of corded drill such as Heavy Duty 240 Hammer Drill and 24V Cordless Hammer Drill with Accessories, Wolf 810 watt 240v Impact Rotary Hammer Drill Variable Speed.
There should be no problem at all.
As of 2000, Australian power points supply AC 230v at 50hz. Pre-2000, it was 240v at 50hz.
The drill bit is struggling to cope with the task. The drill is probably not powerful enough