0
Yes, a bad belt or tensioner can be related to a rough idle. If it is not tight enough, or worn it is not able to run as smoothly as needed to keep the engine running smooth.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
Replaced timing belt and all idlers and tensioner now rough idle and a miss never did it before whats up?
Cam or cams not lined up with crank properly
Why does your 97 Lexus ES300 idle rough after changing the timing belt?
You do not have the correct timing set for that car.
How do you move the idle tensioner for a 1998 3 liter dodge?
"How do you move the idle tensioner for a 1998 3 litre dodge?"
Will a bad egr valve cause your car to idle rough or die?
It is a common suspect in contributing to rough idle. See "Related Questions" below for more about the EGR valve, from testing to replacing.
Why is your 2004 Chevy Malibu hard to steer at idle or low speed?
check the serpentine belt tensioner for being bad, it might not be keeping the drive belt tight enough against the pulleys.
Replaced timing belt and all idlers and tensioner now has a miss and rough idle car was fine before this Whats up?
Chances are the Timing gears or pulleys are not properly aligned. The Cam shaft and the Crank shaft must be aligned properly so that the valves and pistons are "in sync"
What causes 1999 suburu legacy to knock-click during idle?
Sometimes the Timing belt tensioner will cause a tap or click until the engine is warm.
How do you adjust the idle pulley on a 1996 Plymouth Grand Voyager?
== # Loosen the idler pulley lock nut # Turn the adjusting screw to lower the idler pulley # Remove A/C belt. == # Install A/C belt over pulleys. # Apply a snug torque to the idler pulley lock nut. # Turn adjusting screw until proper belt tension is obtained. # Tighten idler pulley lock nut to 54 N·m (40 ft. lbs) == The Poly-V generator/power steering pump belt is provided with a dynamic tensioner. == WARNING: DO NOT ALLOW DRIVE BELT TENSIONER TO SNAP BACK, AS DAMAGE TO TENSIONER AND/OR PERSONAL INJURY COULD RESULT. # Remove air conditioning belt. Refer to procedure in this section. # Apply a force in a clockwise direction to the tensioner pulley bolt # Remove belt. == # Install belt over all pulleys, except for the tensioner pulley. Refer to for belt routing. # Apply a force in a clockwise direction to the tensioner pulley bolt # While holding tensioner, position belt over tensioner pulley. # Slowly release force on tensioner. # Verify belt is properly routed and engaged on all pulleys.
Why does your 2001 Kia Sportage idle rough?
Why does my 2001 kia sportage idle rough?
How to fix a rough idle Nissan?
why does my vr commodore idle rough when at complete stop
Rough idle smell of gas ford windstar?
rough idle smell gas
Does the 1999 Chevy Cavalier 2.2L have a timing belt or chain?
The 2.2L and 2.4L uses a chain.a bad chain or tensioner will make the oil light come on at idle
