Should be located at the passenger side firewall
Some are accessed under the hood others behind the glove box area Remove the wiring harness
Remove the air intake hose
Remove 3-4 small bolts
Remove blower motor
This is a terrible question. Installing it on what? Learn how to ask better questions!
The blower resistor assembly is located under the hood, on the heater case to the right of the blower motor. Haynes Manual #36071
see a real mechanic
If you have no air coming out of the vents then you need a new blower. If you have air but no heat its either the hot cold selector not moving the flap or its the heater matrix. First things first. Check the fuse for the blower (if you get no air). Everything except the fuse need a mechanic or very keen DIY expert with a Haynes manual to hand.
The blower resistor assembly is located on the heater case to the right of the blower motor. - Haynes Repair Manual #36071, 1993-2005 Ford Ranger Pick-ups
Looking at the picture in my Haynes repair manual it looks like the blower motor resistor is in the engine compartment mounted just to the right of your blower motor when looking from the front of the Explorer - Helpfull
According to the haynes manual it is under the glovbox on the blower box but it isn't theres in a 1998 BMW z3 and i am trying to research the location
A heater blower in a 2005 Chrysler Pacifica is a complicated process. To get this [project done, you will have to go to a mechanic and have it done.
I dont know anything about cars but my blower stopped working in my car and I took it to the mechanic and he changed a fuse and it started working again. Then a couple of months later the blower stoped blowing again and I took it back to the mechanic and he said the fuse is fine it might be the blower moter, how can I tell, I think it's a loose wire because my radio was removed and everysince my radio was removed my blower has been giving me problems.
Loose belt -- replace or lubricate ADD-ON If it is a metallic squeal that continues for a minute or so after the car starts it could be your water pump bearing. Get your mechanic to check it out and replace before you need a tow truck.
I had the same problem with my 98. My mechanic found a loose wire at the blower motor connection.
The blower resistor assembly is located on the heater case to the right of the bloser motor. - Haynes Repair Manual #36071, 1993-2005 Ford Ranger Pick-ups