I'm not sure if it is but I plan to do exactly the same thing in a couple of weeks. I used the 'gold' version of waterproof, OSB-type tongue and groove boards - 4x8. The boards are glued and screwed onto steel floor trusses that are designed to handle the weight of the gypcrete.
If you've learned more since you posted the question - please share.
Regards,
VB
thumki@Yahoo.com
____________
Yes, you can do that. It is normally done in two stages - 1st just enough to cover the tubing and next pour (+1/2" at least) to level the flooring surface.
FIY, thermal mass is always preferred vs. lightweight concrete.
to cover windows
No
Under the valve cover there are seals on top of the plug tubes, you will need to replace the valve cover gasket and plug tube seals.
villi
It is the wooden frame with holes in the top, most hold about 4-7 test tubes.
Many insurance companies will not cover tubal surgery unless there is a risk of fatality. To get tubes untied is usually considered an optional surgery and insurance companies might not pay for this type of surgery, but each company is different in what they cover.
Depending on your covering needs there are basically two options. 1) Safety Cover needed? The only way to cover a pool this way is to have a custom Safety Cover made. It requires A/B measurements and is anchored with brass anchors in decking or lawn tubes in other types of decking. 2) Winter cover to keep leaves and debris out of pool? You'll need to find a rectangle cover that is large enough to cover the pool. Use water tubes to fully encircle the perimeter of the pool to ensure that wind doesn't get under the cover. Roll or fold up the excess cover and weigh it down with the water tubes.
Radiant floor heating, or floor heating, is accomplished by supplying heat directly to the floor. This type of heating is far more energy efficient than forced air heating as nothing is lost through ducts. There are three types of floor heating: radiant air floors, electric radiant floors, and hydronic radiant heat. The hydronic floor is a liquid based system that uses little electricity and is the best choice in areas with high electricity costs. The method for installing electric or hydronic radiant systems are very similar. The wet installation is the oldest form of these flooring systems. In the wet installation, the cables or tubes are laid in the concrete slab foundation of the home. High heat capacity is possible when installing the system in a thick concrete slab. A dry installation is when the cables or tubes are suspended between the joists, underneath the subfloor. This type of installation requires the use of reflective insulation under the cables or tubes. This will make sure the heat is reflected up through the floor and not downward. There is now an improvement on the dry installation process. This is done by using a plywood subfloor made with built in tubing grooves and heat diffuser plates. This can make the installation less expensive and heating more efficient than a regularly dry installed system. Ceramic tile is the best choice for floor covering over the radiant heating system. Other floor coverings can be used, however, it must be remembered that the floor coverings can cut down on the efficiency of the heating system. Ceramic tile conducts the heat instead of insulated the house from the heat. Once your flooring heating system is installed and operating, you will immediately experience the benefits. One the lesser known advantages of a floor heating system is beneficial for the allergy sufferer. Since air is no longer forcing heating through the house, dust and allergens are no longer being forced through the house. The air is also not being dried out by the heating system, eliminating the need for humidifiers in the house. The biggest benefit of course, is not having to walk on a cold floor.
There is a gasket underneath the valve cover that goes around the outer edge and around the center of the cover around the spark plug tubes. These gaskets are prone to leakage and must be replaced.
Take off the plastic cover on top of the engine and you will see the coils & plug tubes with the plugs at the bottom of the tubes
SIC 3641 covers makers of electric lamp bulbs and tubes
the valve cover gasket is bad, or the valve cover is loose