Fuel and Fuel Intake
Pontiac Trans Am
Air Filters and Intake Manifolds
Ford Escape XLT

Is the intake manifold on a 305 interchangeable with one on a 350?

606162

Top Answer
User Avatar
Wiki User
2011-09-13 05:26:26
2011-09-13 05:26:26

yes

edit

Not always. You haven't said what kind of 350 you're talking about. Is it an LT1? Is it a Vortec? Is it an LS1? If you said yes to any of those then the answer is likely "NO" for LT1 and definitely "NO" for the others.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Yes it will. It will bolt right on... 100% interchangeable.

User Avatar

Yes, they are 100% interchangeable, so it will bolt right on.

User Avatar

Unlike chevys 305, 350, and 400 which are interchangeable. The Ford 302 and 351 are not interchangeable.

User Avatar

The connector into the intake manifold of a GM 305 and 350 has been known to be quite fragile. If the connector has broken you have little choice but to replace the manifold.

User Avatar

the manifolds should be the same for the 350and 305. be careful, however about the year of your manifold, older manifolds have the four center holes drilled at the same angle as the heads and the rest of the holes, newer manifolds have the four holes drilled straight up and down, and the two are not interchangeable

User Avatar

yes it will fit, 262-400ci chevy smallblock manifolds are interchangeable.

User Avatar

no, the bolt pattern on the small block Chevy intake manifold changed in '87 to the vortec head design, but if it doesnt have the centerbolt valve covers, then it will.

User Avatar

yes if it is an older model pre 95 if both had carbs. on them then yes they will interchange.

User Avatar

yes it will fit, any smallblock Chevy intake from 86-55 are interchangeable, the 86 and newer have bolts that go staight down instead of on a angle

User Avatar

Yep! The transmissions are completely interchangeable.

User Avatar

On a small block Chevy the distributor goes through a hole in the intake manifold. On a Pontiac the distributor goes behind the intake manifold.

User Avatar

Intake valves are larger than exhaust valves, and are aligned with the intake runners on the intake manifold.

User Avatar

In the thermostat housing at the front of the intake manifold.

User Avatar

It depends on what you have to remove to get the intake manifold off. Once the intake manifold is off it will take about an hour.

User Avatar

The 350 cubic inch Chevrolet intake manifold bolts have a torque specification of Haiti pounds psi. The bolts should be torqued at 40 pound intervals.

User Avatar

There is no information on the internet about what the special feature of the Chevy 305 engine is, in fact, the Chevy 305 and 350 are interchangeable, one is just an older model.

User Avatar

Intake Manifold (Cast Iron Heads) Non- Hardening Sealer 30 ft-lbs.

User Avatar

Absolutely! It bolts to a 305 exactly the same way it bolts to a 350... It's completely interchangeable.

User Avatar

If both engines have a carburetor on them, THEN NO. They will interchange.

User Avatar

yes it will all Chevy small blocks after 1986 through 1995 use the same angle and bolt pattern for the intake........if its aluminum make sure you get a high seal gasket....


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.