Cooler lines should fit.Check and see if you have a 904 or 727 transmission. It should work fine, Good luck.
An external transmission cooler is normally added in line with a vehicles already existing transmission cooler built into the radiator its function is to cool the transmission only. Adding, replacing and or repairing a transmission cooler would only benefit the transmission by cooling the transmission fluid. The transmission cooler is used mainly for cooling transmissions that pull heavy loads like trailers but is also used a lot in racing to keep the fluid cooler which helps reduce transmission overheat or burnout. , EzForJesus
These are cooler lines, the fluid flows in them from the transmission to the cooler in the radiator or auxiliary cooler then back on most vehicles to help in keeping the transmission from overheating ASE certified tech / L1
Many automatic transmissions use a cooler inside the vehicles radiator to help maintain the transmissions temperature. The transmission pumps ATF thru the cooler. If a leak occurs in the trans cooler the ATF is pumped into the radiators coolant. The engine coolant can also mix with the trans ATF and enter the transmission the same way in which case would be fatal for the transmission.
If you run the transmission low on fluid you can cause damage. Fix the leak.
545RFE - Automatic Transmission Service Fill 2WD 5.2L (11 pts.)Service Fill 4WD 6.2 L (13 pts.)O-haul Fill 13.33 L (28.0 pts,) NOTE: Dry fill capacity depending on type and size of internal cooler, length and inside diameter of cooler lines, or use of an auxiliary cooler, these figures may vary.42RLE - Automatic TransmissionService Fill 4.0 qts (3.8 L)Overhaul Fill 17.6 pts (8.3 L)Note: Dry fill capacity Depending on type and size of internal cooler, length and inside diameter of cooler lines, or use of an auxiliary cooler, these figures may vary.
It is in between the cooler hoses on the front of the transmission.It is in between the cooler hoses on the front of the transmission.
difference between cooler and heat exchangers
Entreprenuers are cooler.
The difference is that mms is cooler than sms
It is much better sounding and cooler. Much cooler then Reilly.
Type your answer here... the basic difference is the phase of the material which is to be cooled i.e.in condencer it is in vapour phase & in cooler it is in liquid phase.
secondary is cooler
lions are alot cooler
If there are lines coming from the transmission to the radiator, it has a cooler in the radiator. If there are lines from the transmission to an external heat exchanger, that would be an auxiliary cooler.
Transmission Coolers extend the life of your transmission.
It is on the front of the transmission, next to the cooler hoses.It is on the front of the transmission, next to the cooler hoses.
An external transmission cooler is normally added in line with a vehicles already existing transmission cooler built into the radiator its function is to cool the transmission only. Adding, replacing and or repairing a transmission cooler would only benefit the transmission by cooling the transmission fluid. The transmission cooler is used mainly for cooling transmissions that pull heavy loads like trailers but is also used a lot in racing to keep the fluid cooler which helps reduce transmission overheat or burnout. , EzForJesus