To the best of my knowledge and information I have checked out, there should be two Freeze plugs in that location.
On the back of the engine, mounted between the engine and transmission, inside the bell housing. You cannot see the flywheel. The starter is connected to the flywheel when you start the engine.On the back of the engine, mounted between the engine and transmission, inside the bell housing. You cannot see the flywheel. The starter is connected to the flywheel when you start the engine.
Connected to the flywheel housing.
In theory, if you can find a transmission housing, flywheel, and clutch that will attach to this engine.
Passenger side, mounted on the bell housing, connected to the flywheel.
The bell housing is the front part of the transmission where it bolts to the engine. The bell housing surrounds the torque converter and flywheel.
It is located between the back of the engine and the transmission. It houses the flywheel and clutch if it is a standard or the flex plate and the torque converter if it is an automatic transmission.
It is the area between the engine and transmission.
If the truck is a 4 wheel drive it would be easier to remove the engine to replace the flywheel. If the truck is a 2 wheel drive removing the transmission and bell housing is the way to go.
Bell housing. Contains the clutch & flywheel on a manual transmission vehicle. On an automatic it contains the torque converter.
look for it around the transmission bell housing, the bendix gear in the starter motor has to mesh with the flywheel inside the transmission bell housing in order to turn over the engine.
yes theres an braided ground wire that bolts to the transmission bell housing
NO. You will have to remove the transmission bolts and move the transmission back alittle after you have removed the driveshaft,transmission lines,crossmember bolts,starter,flywheel dust cover,front driveshaft,torque converter bolts. NO OTHER WAY.