To reset the computer, disconnect the negative battery cable, turn the ignition switch on, then back off, and rehook the battery after about 15-30 minutes.
sorry to say I have been working for Dodge for 25 years and I have never herd of a reset button for the transmission. Do your have a light on?
Take the car back to the dealer. Push in on the oddometer trip reset button, turn the ignition on, and hold the button until the display goes to 00.0.
its on your rear end and armpit loser hair
I'm not sure what is wrong with your tranny but they do not have a reset button! They have Transmision control modules (TCM) that you need a $2,000 tool to reset any codes!
On some cars there is a reset button in the fuse panel, check with your cars manual to see if they tell you how or where to look. There is no reset on a 300m. If the oil light is on, you are low on oil, have a bad sensor, or a engine malfunction.
The tire reset button is to reset your tires.
Shut off the car with the odometer showing the "Trip A". Then, while holding down the reset button, turn the ignition to the "On" position. There will be 6-7 lines showing instead of the odometer numbers, and they will disappear one by one. Keep holding button down. Then all "0's" will be displayed, and finally it will show the mileage. Reset complete.
There is not a reset button.
The reset button is a button that when clicked, will clear all of the fields
It is a reset for your fuel pump and located on the passenger side just to right of the transmission hub. You have to pull the carpet down from the top to see it.
Hold in reset button on speedo, turn on ign then release button,then turn it to the right and release it then switch off ign. This will only work if service is due now or showing nearly due
The way to reset a therapeutic heating pad when it says F2 is to unplug the heating pad. It the error code F2 is still showing, you will need to call the company or return the heating pad in case of malfunction.