0
Add your answer:
Earn +20 pts
What can cause the Clutch not to Engage to change gears on 1991 Chevrolet Truck 4X4?
BAD clutch slave cylinder, wore out clutch and pressure plate.
How do you install clutch slave cylinder on a 1994 F250 4x4 7.5L?
The part tat goes where the tramison
Where is the clutch slave cylinder on a 1993 ford ranger 4x4?
I believe that is inside the manual transmission bell housing
What would make the clutch stay to the floor on a 1984 4x4 Toyota truck?
no fluid in reservoir due to leaking reservoir or slave cylinder
Would a faulty transfer case cause transmission problems 1988 ford 250xl 4x4?
could the tranfercase cause the clutch too hang up or is it the clutch slave,that could be hungup..
Why do you have to turn a lot of RPMs for the transmission to shift in a 1992 Nissan 4x4 pickup?
your clutch may be slipping ,first check and see if your clutch slave cylinder is leaking,check your clutch master cylinder to see if your fluid level is ok.if level is ok and no leaking slave cylinder,then you probaly need a new cluch.
Where is the slave cylinder for the clutch on a 1996 Toyota Tacoma 4x4?
The slave cylinder is located on the driver side of your bell housing going to your motor. Its a cylinder about the size of a roll of quarters.. maybe a little bigger.
1989 ranger 4x4 XLT you put a new tranny in it and put a new clutch line on How do you regain pressure in the line was told to press the clutch several times Do you do this with fluid or without?
With fluid. There might be a bleeder scerw on the slave clinder.
Why would a 1988 Chevy K2500 4x4 clutch pedal go to the floor and return but not disengage the clutch?
IT is low on fluid or the clutch cylinder is bad or the slave cylinder on the transmission bell housingAnswerOR the pressure plate colasped-OR linkage is broke - but only if the slave cylinder is moving. AnswerUpon further inspection I have found out that I have a leaking steel line from the clutch master cylinder to the slave cylinder. Thanks again for the replys!!!! What if the pedal is pumped and the pressure returns then works properly? could this be from low fluid or something to do with the reservoir or a leak in the line?
Download 2000 Kia Sportage trouble shooting?
i sound forward and I believe that the 4x4 will clutch on my own and it can not, I do not touch the arm of enbrayage of 4x4 and 4x4 when the arm is diparrait clutch noise, is there a maintenance or adjustment to fix this problem?
Will a 1989 4x4 Jeep Cherokee transmission fit on a 1994 4x4 Jeep Cherokee?
I don't think it will...=( I have a 1989 Cherokee limited and it is 2x4 with 4x4. if you don't have 4x4 on ur 96 then i really don't think it will work, but if it is like the 89 with 2x4 with 4x4 then it might just work.Answeri am about to take a 89 Cherokee 4x4 tranny and put it into a 96 2x4 Cherokee. i belive they will bolt up, but i am still not sure. it will be a couple of weeks till i get to that stage, but i will let you know how it all went. AnswerI am not sure it will, is the 89 a four wheel all time? i know the 94 is four whell drive all the time, might wanna ask a jeep dealer... good luck
Can a clutch on a 1996 chevy 4x4 5 speed be adjusted?
Yes, it can be.
