0
Is there an ignition timing setting for 1994 Pontiac Sunbird 6 cylinder engines or is it all controlled by a computer?
Wiki User
∙ 17y ago
I wondered the same thing on my 1992 4 cylinder.. if there was any form of sensor besides just the computer telling spark plug 1-fire now or 2-fire now,ect. I think if you have the electronic ignition like I have its just the computer.. but im not certain of this.
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
How do you set the timimg on a 1993 Pontiac Grand Am 6-cylinder?
Computer controlled and not adjustable
Can you replace the ignition lock cylinder on a 1994 Pontiac firebird without removing the steering wheel?
You can replace the ignition lock cylinder in your 1994 Pontiac Firebird without removing the steering will. Remove the retaining ring at the top of the ignition cylinder. The ignition cylinder will slide out.
How to fix a 1996 Pontiac grandam ignition locked?
Replace the ignition lock cylinder.
How do you install ignition lock cylinder in a 94 Pontiac Bonneville?
Attach the wiring harness to the end of the ignition lock cylinder. Slide the ignition lock cylinder into the slot. Tighten the retaining ring at the top of the cylinder.
On 1998 Pontiac ignition key will not copletely turn off and shift is in park?
the ignition lock cylinder is bad
How do you replace the ignition in a 2001 Pontiac Grand Am?
ignition what? coil, swicth,module, lock cylinder? gm Jim
Why does an ignition cylinder go out in a Pontiac firebird?
It is a common problem in most GM vehicles.
Where is the Ignition switch on 1997 Pontiac Sunfire?
On the column accross from the key lock cylinder
How do you remove the ignition lock cylinder on a 1994 Grand Am?
The 1994 Pontiac Grand Am ignition lock cylinder is held in place by the retaining ring at the top of the cylinder. Remove the retaining ring. Remove the wiring harness from the back of the cylinder.
How do you get center of ignition on Pontiac Bonneville?
I think you are trying to time the ignition to top dead center. If that is the case the crank position sensor tells the computer when to fire the spark plugs. This sensor gets pulsed by the gear on the crankshaft and depending on where this gear is at in its rotation the crank position sensor lets the computer know where the pistons are at in the cylinder. So the whole thing is computer controlled and a timing light is not used. Of course I'm assuming your car is an OBDII model.
Do you need to replace the ignition lock cylinder when you replace the ignition switch on a Pontiac Sunfire 1999?
No, not if it is not defective. If the ignition switch is defective then that is all you need to replace.
How do you change the idle on a 1988 Pontiac Fiero 2.5L 4 cylinder?
This is controlled by the computer. You can set the throttle opening to prevent wedging and sticking but this should not change the idle speed.
