Can you get access to it by removing the interior/trunk panel? Mark
Maybe its your driver-side window regulator that stopped working.
The door switch is bad. I have replaced the drivers side door switch on mine for the same reason.
Probably a bad switch in the drivers door.
the lever is located near the drivers seat. Pull it and the hood should pop. Then check to see if there is a switch and switch it. Then pull up the hood
Check the drivers side switch panel for the switch that locks out the passenger windows from working, make sure it is not on.
On my '86, 300zx NA, the rocker switch on the console turns on the heated outside mirror (drivers side).
Often the plug in connector at the drivers side switch can becaome loose and break the connection. Remove the switch and check this.
if it is a factory alarm, you have to unlock the door with a key from the outside. most likely the switch is busted on the drivers side so try the passengers side. if it works, go buy a switch for the drivers side. the switch is on the end of door lock cylinder.
Always check the fuses first. Mirrors implies both. Fuse, switch, loose connection at switch.
Had the same problem my self last week. Take a hot wire and a ground and jump out the switch. Changes are the master switch went bad on the door panel. Ken
GO TO WWW.EHOW.COM AND IT WILL EXPLAIN EVERYTHING TO YOU
in my trail blazer i took the whole switch assembly apart and discovered that a miny diode had fried. It is a matter of replacing the switch assembly.