0
Just changed the plugs wires distributor cap and rotor yet my 1999 Chevy Astro van still hesitates a second or two before accelerating Any Ideas on the fix?
Wiki User
∙ 15y ago
sounds like a possible timing issue. the timing has to be right on or it will hesitate if gunned from a stop. do you have a good clean spark ?
i have going through the same thing my mechanic said it is bad injectors havent tried it yet but will next week
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How do you sum up these two proverbs look before you leap and he who hesitates is lost?
Think before you act, but not too much
1998 Chevy 1500 4.3 liter trucki changed the gasket on the upper intake manifold pulled the distributor while doing the gasket repairnow engine won't run truck was running before repairs battery and s?
you've got the distributor off 180 degrees...
No spark on 90 integra?
the electronic ignitor on the distributor is fryed.. chances are the distributor is taking them out, replace the ignitor and the distributor, but before this, make sure you didnt break your timing belt...
Where is egr valve in astra 1.6?
before air distributor
What is the dizzy on a mustang?
The distributor ( before distributorless ignition systems )
What degree before top dead center is the distributor on a 2992 Isuzu amigo 2.6l?
there should be numbers on your distributor cap inside and out
Was Alec volturi changed before Jane?
Yes. Alec changed before Jane because he was elder to her and Jane was too young to be changed into a vampire before Alec.
95 Nissan Maxima where is the distributor cap?
can the distributor cap make the your car take 3 or 4 tries before it crank up
How do you install a distributor in a 1996 Yukon?
I removed the distributor in my 96 gmc yukon but I forgot to mark it before removing it.What do I need to do to get it back in.
Where is 1 on distributor cap for 1978 350?
before #8 and after #2
Should the distributor face forward or backward on a Chevy 350?
The distributor should face forward rather than backward on the Chevy 350. It is important to mark the front face of the distributor before removing it.
Does the rotor have to point to a certain firing order before you place the distributor cap on the distributor?
I'm not a mechanic / technician but ( no ) If you are only replacing the distributor cap , it only fits on ( 2 ways ) The correct position and 180 * out
