answersLogoWhite

0


Best Answer

it sounds like you need a master cylinder from the dealer make sure your wheel-lock isn't putting pressure on the ignition

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Key is stuck in the ignition of 97 VW Cabrio and you cannot turn it to start or turn to remove?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you remove a key that is stuck from the ignition of a 1996 Dodge Caravan Steering wheel is not locked and cannot start the vehicle?

You can't, you have to replace the ignition switch


Your gmc envoy won't start and key is locked in ignition?

My 2002 GMC Envoy won't start,no lights come on when trying to jump start the battery. And my key won't remove from the ignition. What's should i do?


How do you remove the ignition switch from a 1992 Honda Civic?

You need to turn the ignition to the on or start position, and then push the retaining pin to remove the cylinder. If you can not turn it, then you can either drill it out, or call a locksmith to come asist you.


What are symptoms of a bad ignition coil?

A bad ignition coil will cause your engine not to have any spark. Without any spark the engine cannot start or run.


Can the pass key system on a 1993 Olds Regency 98 be completely removed and allow the car to still start up and be drivable?

No you cannot remove the system how ever there are ways to bypass it. You can by pass it at the ignition or you can by pass it at the module.


How do you change or fix an ignition switch on a 1988 Corsica when the key turns but does not actuate anything?

If your 1988 Chevy Corsica key only turns in the ignition and does not start the automobile, it is probably unfixable. Remove the ignition switch retaining ring. Slide the out and remove the wiring harness. Reverse the process to install the new ignition switch.


How do you remove the ignition switch on an 88 Pontiac Bonneville?

I have to jump start my Pontiac Bonneville 1988 everyday I drive it why is that.


If you remove all the tumblers from the ignition lock cylinder on a 1994 Saturn SC2 can you still start and drive the car but just not have a lockable ignition and steering wheel?

Should be correct


Remove ignition switch 1992 Dodge Dakota?

I removed my ignition switch with a screwdriver and a power drill. I warn you it damaged the whole system though. I have to start it with a screwdriver now.


How do you install a key ignition on a 1980 El Camino?

remove the steering wheel and the turn signal mechanism. Then there is a screw right in front of theignition. Remove the screw and pull out the ignition. Should take no longer than 30 to complete from start to finish.


How do you start a 1979 Chevy pickup with a broken ignition?

remove the ignition tumbler from column and crank it with a insulated handle flatblade screwdriver if the ignition is located in the dash remove key tumbler by inserting a small pin in the hole located above the key hole and it will pop out using a screwdriver and turn it over that way


Why would a 95 1.9L escort wagon start when you press the clutch with the ignition off?

Remove the transmission oil pan for access