answersLogoWhite

0


Best Answer

I found this site, http://installdr.com/InstallDocs/Acura/Integra.html, hope it helps.

User Avatar

Wiki User

17y ago
This answer is:
User Avatar
More answers
User Avatar

Wiki User

16y ago

Buy a manual from an auto zone or advanced auto parts its in the back of the book

This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is a wire diagram for a 2000 Acura Integra?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Wire diagram for a 1987 Acura Integra?

im loking for gas filter im loking for gas filter


Where can i find a 97 integra ls distributor wire diagram?

You can find a distributor wire diagram for a 1997 Integra in the auto's owner's manual. You can also find it in some auto part stores.


What colors are the starter and power wires on 96 acura integra?

power is Black or Black and yellow starter signal wire is black and white see wiring diagram link below..


How do you change a starter on a 1993 Acura Integra?

To change a starter from a 1993 Acura Integra remove the mounting bolts that connect it to the transmission. Then unplug the solenoid from the wire harness. Install the new unit.


How do you get the emergency light to go out after the emergency brake is released 1991 acura integra?

cut the wire


How do you fix the tachometer on a 91 Acura Integra?

The tachometer on a 1991 Acura Integra is wired through the dash. To reach the wiring remove the dash console and pull out the tachometer. There the wiring can be worked on using a spark tester to find the bad wire and solder unit to replace the wire.


How do you fix the horn on a 1997 Acura Integra?

The horn on a 1997 Acura Integra uses one wire. When a horn stops working it is usually due to a bad fuse. To fix the horn replace the fuse labeled HORN.


Where is the backup light switch on an Acura Integra?

it is under the transmission. u can see part of the wire when you are looking into the engine bay. the wire should be close to the radiator.


Where is located Oil Pressure Sender of 1991 Acura Integra?

on the back of the engine block, beside of the oil filter. It is the wire with a black boot with 1 wire.


How do you check ac compressor on 1990 acura integra gs?

jump a hot wire downt to it with it running with gauges on it and read the readings.


Where is the speed sensor located for a 1989 integra?

The speed sensor on a 1989 Acura Integra is located on the transmission. It is a small unit with a two-wire clip which connects to the main engine harness of the vehicle.


What are the stereo wiring color codes on a 1990 Honda Integra?

There is not a car made by Honda called an Integra, however Acura does make an Integra. For the 1990 Acura Integra, the radio constant 12v+ wire is blue/white, the radio switched 12v+ wire is yellow/red, the ground wire is black, the illumination wire is red/black, and the antenna trigger wire is yellow/white. For the front speakers, the left front speaker wire (+) is blue/green, the left front speaker wire (-) is gray/black, the right front speaker wire (+) is red/green, and the right front speaker wire (-) is brown/black. For the rear speakers, the left rear speaker wire (+) is blue/yellow, the left rear speaker wire (-) is gray/white, the right rear speaker wire (+) is red/yellow, and the right rear speaker wire (-) is brown/white.