answersLogoWhite

0


Best Answer
Answer oil pressure problemI would think that you need to replace your oil pump or make sure the pan gasket hasn't rotted and fell in the oil pan and is stopping up the pick-up tube.If its not the oil pump then you have a bearing problem,I would start with the oil pump first.Hope this help Ricky B.

Yes i would start with the oil pump. But it sounds to me like the dreaded cam bearings.

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Oil pressure problem 98 Silverado 350 after engine warms up you get little to no oil pressure at idle and between 25-30 at 2000rpms 57000 miles 3in suspension lift 3in body lift 35in tires?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

2003 silverado 2500hd 6.0 fuel pressure specs?

The 2003 Chevrolet Silverado 2506.0 liter engine fuel pressure should be between 15 pounds and 18 pounds. The specifications are for a new engine.


How can you tell the difference between the high pressure port and a low pressure port to recharge the aircontioner in a 2003 Chevy silverado?

The high pressure fitting is the larger of the two. The adapters and fittings used to add refrigerant can only fit the low pressure side. I have a 2003 Silverado 2500HD and the low pressure port is just above the accumulator/ dryer on a line that attaches to the fire wall.


Where is the vacuum line on a 2000 Chevy Silverado engine?

The vacuum lines on a 2000 Chevy Silverado run between the intake manifold and multiple valves across the top of the engine. The vacuum pressure is generated by the engine's compression.


Difference between suspension and cantilever bridg?

suspension??


What is min fuel pressure on 2002 1500 silverado with a 4.8 liter?

55 LBS is the lowest and 62 LBS is the highest anywhere in between is fine


What is the difference between paracetamol syrup and paracetamol suspension in combination?

what is the differences between paracetamol syrup and suspension? Is there any benefit in choosing suspension formulation?


How do you replace oil pressure sensor for 2005 Chevy silverado truck?

The process to change the pressure sensor is the same for any engine in the 2005 Silverado, but the location may change between engine types. The sensor should be close to the oil filter. Remove the sensor wire, then screw the sensor out. Screw a new sensor in, then reconnect the wire.


Is the ac low pressure port on the same line as the high pressure port on a 2000 Chevy silverado truck has a small port and bigger one the same line a nut is between the two ports is this orifice tube?

Yes and yes. The orifice tube is between the service ports.


What is the main difference between front and rear suspension on vehicle?

The front suspension is steerable.


What is the different between solution and suspension?

Suspension will have residue after filtration, but solution will not.


What is a lower control arm?

An suspension control arm is a link between the suspension that carries the wheel. It is a hinged component that lies between the chassis.


What is the difference between the Suspension bridge and the Beam bridge?

The different between suspension bridge and beam bridge are beam bridge are for short distance but suspension bridge for long distance. Beam bridge are used for highway passes and suspension bridge for wide waterway passes.