Chevy Suburban
Chevy Trucks and SUVs
Ford F-150
Chevy 350

On a 1995 Chevy truck v8 where is 1 on the dist cap?


Top Answer
User Avatar
Wiki User
2008-01-19 22:49:47
2008-01-19 22:49:47

Number 1 on the distributor cap should be located right behind the coil. The two front terminals are #1 on the front right and #8 on the front left.


Related Questions

Check the module under the distributor cap.

It is under the distributor cap. If you look at the right side of the dist. You will see 2 electrical wires that plug into the module that's under the cap.

If your asking this question you shouldn't be working on your truck.

should be in a straight line from center of the distributer cap to the #1 cylinder, or pointing at the #1 cylinder

You're best option is to measure the cap and your truck bed to see how close they match. Good luck!

I don't know what your specific problem is, but there is no distributor cap.

On the dist., cap, where the wires go in, there is a tab labeled TACH.

5W30 And it is written on the oil cap.

We need to know which engine it has.

Check the glove box. That's where I find everything. there is not a tdc you have to have a scan tool to put it in time that is what i had to do on my 97 gmc. the crab cap elmanites that... it is a pain in the butt if you ever have to change the dist.

if you remove the dist cap there is a small peice with 4 wires on it its held on with two screws on the outside of the dist if you remove the dist cap there is a small peice with 4 wires on it its held on with two screws on the outside of the dist

In the distributor,you need to remove the dist cap & then remove the rotor and it will be mounted to the distributor housing

The coil is attached to the top of the distributor cap.

It is 1-6-5-4-3-2- with 1-3-5 on drivers sid. The #1 is the most foreward position on the cap and the dist turns clockwise.

take out the # 1 spark plug turn the motor to top dead center remove the dist. cap and where ever the rotor is pointing is # 1

heat the cap up with a turbo torch and burn the plastic out of the cap groove.

my s- 10 did the same thing i replaced to dist cap rotor and plugs it helped

1-8-4-3-6-5-7-2 clockwise on the dist. cap

form_title=Upgrade Truck Cap form_header=Improve the protection on your truck bed by adding an improved truck cap. What sort of features do you want on your truck cap:=_ What material do you want the truck cap to be made out of?=_ Has your truck cap been damaged in any way?=_

Mounted in the center of the distributor cap.

Follow the wire from the #1 cylinder to the cap. see link

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.