answersLogoWhite

0


Best Answer

What has been your chemistry balance for the year - month-to-month? Without seeing the pool finish, it seems that your pH and alkalinity have been off for months. What chemicals do you add regularly or on a weekly basis? I have much doubt that it was the conversion to salt. A bad plaster job would have other signs. Please, get back to me thru my message board. So that I can further analyze situation.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Pool that was re-plastered in November of 2006 Plaster has become very rough with blue specks showing in it. The pool was also converted to a salt water system. A bad plaster job or something else?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why is the plaster on a gunite pool gray in the middle and white on the gunite side and white on the outside?

The finish plaster is normally white all the way through. It sounds like you are dealing with a pool that has been replastered by the method of putting a "brown coat"/"scratch coat" (the gray plaster you noted) over the original finish plaster surface, and a new finish coat of white plaster on top of that. The scratch coat more like a thin concrete than plaster (doesn't have the white marble dust in it) and is used to get a better bond to the old surface.


How do you make a plaster of Paris mold of a hand?

Do not "stick your hand in a bucket of plaster of Paris" as someone previously suggested!Plaster of Paris can get really hot while setting and you would end up severely burning your hand...A slightly more sensible approach is to make a mould of your hand using something like clay or alginate and then use that mould to create a plaster of Paris duplicate of your hand...


How gypsum is converted into plaster of Paris?

CaSO4.2H2O ---> CaSO4.1/2H2O + 3/2 H2O


What happens when gypsum salt is heated above 130 degree Celsius?

gypsum is calcium sulphate dihydrate on heating it is converted into plaster of paris which is calcium sulphate hemihydrate and it is used for mouldings, CaSO4.2H2O + heat = CaSO4.1/2 H2O or (CaSO4)2.2H2O


What is plaster tape?

plaster tape is tape that you dunk into water (warm) then you put it on masks or on other sculptures but it has to be on something . I did this in 5th grade it was fun I hopeI answered your question .


Will plaster of Paris dissolve if used inside a home made snow globe?

Yes, so the plaster will need some type of water-proof coating. If you are carving something from a plaster block, moulding something out of plaster, or even using a pre-made plaster object, the only way it will not slowly dissolve in the water of the snow globe, is to make sure it is totally covered in some type of water-proof finish. I'd use a minimum of 2 coats to make sure. If there is even a small break in the finish for the distilled water to get under, your finish will begin to peel and the plaster will break down there.


What are the different types of plaster of Paris?

No, there are not different types of plaster of Paris. However, there are different types of plaster. There is plaster of Paris, pottery plaster, Puritan pottery plaster, Cerami-Cal, and Hydrostone.


Why is plaster of Paris called plaster of Paris?

Gypsum plaster (plaster of Paris) ( CaSO4·½H2O ) A large gypsum deposit at Montmartre in Paris led gypsum plaster to be commonly known as "plaster of Paris"


Why does my daughter eat plaster?

she has an eating disorder as she must be lacking something in her body which is most likely to be iron.


What does the word 'hampered' mean?

Something that hampers you is something that prevents or makes it difficult for you to do something. For instance having your leg in plaster will hamper you when walking.


How is gypsum converted to plaster of Paris?

All that needs to be done is to grind up the gypsum and heat it to 300 degrees F. Gypsum contains water, and the heating drives it off.


How do you remove plaster off of brick?

To remove plaster off a brick, try scraping it with a shovel. If that doesn't work, try pouring water on the plaster so it will get soft, and come off easier. As a final result, try using a scythe or something. - a helpful (and smart) 9 year old