Lower tailgate and remove two screws. Pull assembly to the rear and it will release.
You will need to remove the tail light covers in the cargo compartment. Remove the wiring harness. Remove the tail light assembly retaining bolts.
You can access the Nissan taillights from the cargo compartment. Remove the tail light assembly cover. Remove the tail light wiring harness. Remove the tail light assembly retaining bolts.
you have to remove it from the outside.after you remove the screws press the bulb and turn it to the left to remove.
From outside,take a screws out to get light assembly loose and remove light socket from back of assembly and channge your light bulb,then put it back.
in the trunk there are 3 plastic wing nuts take them off and the light will come out.
On my 2005 Dodge Ram Daytona. I had to open the tail gate, remove the two screws on the jam next to the light assembly. After removing the assembly, there is a light bar held by six screws. After removal of these, you can select the bulb you wish to change and then reassemble to install light assembly.
Removing the rear lights on a 2004 Dodge Ram Laramie is a relatively straightforward process. Here are the steps you will need to follow to complete the job:Locate the two screws on either side of the tail light assembly. Use a screwdriver to remove the screws.Gently pull the tail light assembly away from the body of the truck.Disconnect the wiring harness and remove the tail light from the assembly.Install the replacement tail light and reconnect the wiring harness.Reattach the tail light assembly to the body of the truck using the screws.After completing these steps your 2004 Dodge Ram Laramie will have a new functioning rear light!
The cover does not come off. The tail light is an assembly, that is removed as one piece. The fasteners are accessed from in the trunk.
In order to change a bulb in the tail light of a Chevy Celebrity you must remove the tail light assembly from the car. To remove the tail light assembly" 1. In the trunk next to the quarter panel there are nuts that hold the rear header on, the center nut holds the tail light assembly on. It will be in the center of the tail light assembly near the outer edge. Take the nut off and pull the tail light assembly out until the stud clears the body. 2. Pull the tail light assembly to the side to disengage the tabs from the backup light panel. 3. Twist the appropriate socket to remove it from the tail light assembly, then unplug the lamp and replace it. Reverse the steps to reinstall the tail light assembly.
The tail light is an assembly. The lens is not removable. To replace a bulb you remove the assembly by opening the liftgate, removing two fasteners, and pulling the light rearward.
The tail light is an assembly. The lens does not come off separately. The assembly is removed by lowering the tail gate, removing two screws, and pulling lamp rearward.