Not sure about your Venture, but Chevy trucks are: Turn ignition to run (do not start engine). Press gas pedal completely to the floor three times in five seconds. Wait 10 seconds (if you have one of the oil life monitor screens, watch for it to blink.) Turn ignition switch off. Start the vehicle.
No, resetting the light will not fix the cause of the problem.
If your engine management light comes on, there may be a problem with your vehicle. The only way for the light to be removed is by resetting the light. The light needs to be reset by someone with a resetting tool. This is generally your local mechanic.
Check engine light or required maintenance light. Procedure for resetting required maintenance light just answered. Check engine light requires an OBD II to determine problem and turn the light off.
Try turning the key to "on" position without engine running and step on accelerator 3 times
turn the key to the on position engine not running step on gas pedal to the floor three times and wait for light to flash and go out and its reset
If the check engine light is blinking that means an engine cylinder misfire has been detected
You will have to drive it until it comes on.
You can reset your engine service light by holding in the scroll button. Hold the button in until the engine oil life goes to 100 percent. The engine service light will go off.
Resetting the ECM without fixing the reason why the check engine light came on will only lead to the check engine light coming back on soon.
It has to be done with a scan tool. Resetting the light without correcting the problem will be of no use as the light will come back on.
There are pages and pages of things that can cause a check engine light. You need to have it checked with a scantool. Then the code can be diagnosed and repaired.
Depends on which engine warning light you are referring to. If you are referring to the Check Engine light then have the problem repaired that caused it to come on in the first place. They will reset the light. Resetting the light without repairing the problem and it will just come back on.
For the sake of simplicity, what engine light are you referring to?
To turn off a 2002 Honda Civic engine light it needs to be reset. Resetting the light can be done by either disconnecting the battery or removing the ECU fuse.
With a soldering iron?
Type your answer here... no law .do what you want its your car
Try resetting the fuel cut off switch and see if the engine will start
If you are referring to resetting the Check Engine Light then you will need to have someone with a scanner to do it. If you are referring to reprogramming the Engine Control Module then the dealer will do it.
Resetting an engine light on a 1996 Dodge Caravan SE is very easy to do. The battery can be disconnected for up to one minute to make the check engine light go off.
The service engine soon is the same as a check engine light. It has nothing to do with an oil change.
It is normal for it to do that when you reset it. NO worries
Here is the link on how to reset and change engine oil on 08 tundra ( http://www.tundraheadquarters.com/documents/toyota-tundra-5-7-liter-oil-change.pdf )
There are pages and pages and items that can cause a check engine light. You need to have it checked for codes with a scan tool. After repair light can be shut off with scan tool.
disconnect battery cables and touch them together! I have done this and it worked. I have an 05 2500hd