answersLogoWhite

0


Best Answer

your stop light switch may have gone bad. it is located on the brake pedal under dash board. if the tail lights turn on when you turn on your lights then the problem will most likely be the switch '''(easy to replace)'''

User Avatar

Wiki User

โˆ™ 2005-11-03 19:53:51
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar
Study guides
๐Ÿ““
See all Study Guides
โœ๏ธ
Create a Study Guide

Add your answer:

Earn +20 pts
Q: Stop light does not light when brake is pressed already ck bulbs and fuses Montero Mitsubishi 1999?
Write your answer...
Submit
Related questions

Why does parking brake light stay lit on 1999 Mitsubishi Montero sport?

The parking brake light stay lit on the 1999 Mitsubishi Montero sport the parking brake is working and you have not put the light off.


How do you Replace brake rotors 1997 Mitsubishi montero sport?

Remove the tire and wheel from your 1997 Mitsubishi Montero. Remove the brake shoe assembly. Tap on the rotors to loosen them. The rotors will slide off. Reverse the process to install your new rotors.


How do you change the brake pads on a 2002 Mitsubishi Montero Sport?

You will need to remove the tire and wheel from your 2002 Mitsubishi. Remove the brake pad spring. Remove the brake caliper. Reverse the process to install the new brake pads.


Looking for brake light fuse for Mitsubishi montero 1998?

check the fuse box under the hood in the engine compartment


How do you remove front brake rotor on 1990 dodge colt?

They have to be pressed out mechanically. Mitsubishi blew it on this design.


Where is the relays or flasher switch for the turn signal and brake lights on a 1995 Mitsubishi Montero?

The 1995 Mitsubishi flasher relay switch and the brake light relay switch can be found beneath the dashboard. Both switches will be on the drivers side of the dashboard, near the brake pedal.


Reset the stop light switch on a Mitsubishi montero sport?

Look at the upper end of the brake pedal under dash area


Where do you add brake fluid to a 1995 Mitsubishi Montero?

the brake resevior should be located on the driver side against the firewall,clear round cylinder with a white lid ,about 4 inches in diameter


What are the minimum brake rotor specifications for a 2003 Mitsubishi montero?

You can call your local firestone (or any other dealer) they should have a book that they can give you the specs from.


Why wont the brake lights work on my Mitsubishi montero when the i turn on the headlights?

Break lights come on when you step on the break, they do not come on when the head lights are turned on.


2001 Mitsubishi montero ltd makes noise when brake applied?

worn pads, calipers sticking or disks warped, more than likely pads though


How do you change brake rotors on a 2000 Mitsubishi Montero Sport?

you'll need to pop off the grease cap then remove the snap ring to get the hub off to get the rotor off.


Why do brake lights on your 1978 Ford Fairmont come on when brake is pressed lightly but when pressed harder lights go out?

Probably a faulty brake light switch or the brake light switch is installed incorrectly.


When foot brake is pressed which light must come on?

The brake lights.


Where is the horn fuse located on a 2003 Mitsubishi montero sport?

I have an 02 and it is located to the left of the brake. Take off the cover and it was the one below the top right fuse(it is a ten amp fuse in mine)


How do you adjust the emergency brake on a 2002 montero?

put your car in reverse and pull the hand brake. done


Change rear brake pads 98 Mitsubishi montero sport?

Lift up your cart using jack stands for safety. Remove the wheel and take the brake hose off of the caliper body. Remove the two pins that secure the caliper to the bracket and pull of your rotor.


When the foot brake is pressed wich light must come on?

the brake light


Does a Mitsubishi bd2f dozer have brake fluid?

No. The brakes are applied manually. A brake band squeezes a brake drum.


1997 Mitsubishi eclipse brake lights stuck on?

check your clutch and brake fluid


What is the hold button for on Mitsubishi montero?

The hold button as explained in the manual is a 'hill hold' button if you are starting and stopping (off road) on a hill. It will presumably prevent the vehicle from drifting backward as your foot moves between the gas and brake pedals.


What factors affect the speed of a car?

Whether or not the brake and/or gas pedals are pressed, how far they are pressed, & for how long.


How does the pedal brake work?

The brake pedal itself swings on a pivot when pressed, pushing a piston through the fire wall into the master cylinder. Forcing brake fluid through the brake lines into a proportioning valve, then into the brakes themselves, bringing the vehicle to a stop. As soon as the brake pedal is pressed, it activates a switch that turns the brake lights on.


What does the Mitsubishi Montero owner's manual say about the brake light indicator staying on when the emergency brake is NOT in use?

If your vehicle has separate dash panel warning lights for brakes and emergency brakes, then the e-brake light being on while not engaged may indicate that the e-brake switch may be maladjusted or faulty. If the brake warning light is on, it may indicate a brake fluid leak, or in some cases, low brake fluid levels in the reservoir. If your vehicle has a shared warning light for e-brake and brake warning, all causes listed above could apply.


How do you replace a bulb in the rear stop light on a 2003 Mitsubishi montero sp?

I am guessing brake lights? But there are two screws inside of the truck that need to be removed - freeing the light (all but the wires) you will then need to remove the bulb by twisting counter clockwise.