answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered 2006-10-17 23:13:17

there are 3 ways to do this. 1. unlock either front door with key. 2. turn ignition on. 3. use keyless entry key to disarm system.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Loading...

Still Have Questions?

Related Questions

How do you adjust the valve timing in most cars?

It depends if it is an OHV(pushrod motor) or a s.o.h.c./d.o.h.c. motor. Ohv engines can have a timing chain set that allow for adjustment, to be installed. You can also install crank keyways that adjust the timing by moving the crank cam gear the required degree/s. Overhead cam engines can have cam gears installed that allow for cam adjustments.


Do motors have cranks?

In a sense, motors do have cranks installed. It is the starter that acts as a crank to turn the engine in order to create a spark and start it. Any device, whether manual or electrical, used to rotate the motor in order for it to start, is called a crank.


Where do you replace the Crank Position Sensor in a 1993 Oldsmobile 88 Royale?

on the front of the motor under the front crank it has a plug going to the crank.


Can you turn a crank on a motor without removing it?

NO, my god no


Where is the crank sensor on a 1992 s-10 blazer 4.3 w motor?

It does not have a crank sensor.


Where would power factor capacitors be installed on a 3 phase motor?

Power factor capacitors can be installed on a three phase motor between the motor contactor and the overload heater block.


If you have power going to the coil and starter but the engine does not turn over where is the problem?

does the motor spin..ie..crank? if no possible locked up engine..try spinning it by hand..correct size socket on front crank bolt turning clockwise.. possible bad starter motor does the starter engage when the key is in the crank possition. if the motor does crank your looking at a fuel or ignition problem


2000 ford explorer will not crank it will turn over but won't crank?

problably your crank positioning sensor, on the front of motor, behind crank pulley. about a $40.00 dollar part. good luck


Why do you keep breaking motor mounts?

replace crank sensor


How do you finish the mech in steamworks island?

You have to get the mech crank and the motor.


What makes a Car not crank but does click?

faulty starter motor


How do you crank shut a Toyota Camry Moon roof?

you can't crank it shut, the motor is electronically worked by a switch. You will probably need to replace the switch or the moonroof motor is no longer good.


What should you do if you have spun a bearing in your motor?

you have a couple options, you can pull the motor and have it rebuilt swap in a used motor from a junk yard drop the transmission and pull the crank, replacing it with a new crank rods and bearings if you are lucky you may not have scored the crank and you can replace the one bearing ang rod or you can junk/sell the car


Will a dirt bike crank when its low on gas?

yes it will crank, because cranking of the engine depends on the starting motor,it has nothing to do with fuel.But remember it will just crank not run.


What way does the crank turn on a gm 350?

The crank for a 350 Chevy turns clockwise or to your right if standing in front of the motor .


Were is the crank shift sensor at on a 94 ford ranger 4.0?

Where is the crank sensor located on a 94 ranger 4.0 motor


How do you get the timing mark on the crankshaft in line with tdc on number 1?

There's a nut/bolt on the front of the motor in line with the crank shaft,actually on the front of the crank. Find a wrench/socket that fits and turn the crank/motor until it lines up. D.Werkman123


How do you get the window up?

if you installed a new motor you have to unhook the battery (about 15 to 20 min.) so the computer can pick up on the new part installed. then work the motor from drivers side.(if passenger side was installed)


How can you write a sentence about a motor car with apex in it?

"I drove my motor car to the apex of the mountain road and returned by the same route"


What is an engine flywheel?

A flywheel is on the outside of the motor, typically has fins on it, it is weighted to keep the inertia of the motor spinning to help crank the motor over


How do you crank the engine on a motor boat?

There are many different ways. On an outboard motor it can be a rope, pulley or an electric motor. Inboard engines are usually bigger and have electric, pnuematic or hydraulic starters. They can also be turned over with a hand crank if not too large.


What is the crank rotation on a big block Chevy?

From the front of the motor, clockwise.


What is a350 cubic in motor bored 060 with a 400 crank?

388


Crank sensor location on 1994 Nissan pickup?

inside motor


Where is the crank position sensor on a 1994 S10 blazer with a vortex motor?

That truck still has a distributor, it doesn't have a crank position sensor.