depending on the engine package your truck was built with your output will be between 300-325hp and 360-370 lb-ft
60 ft lbs and dont foreget the red locktight!
hi what is the sequence and torque on engines detroit diesel 60 series 12.7L 430/470 horse power ...
60-to 70 ft. lbs. of torque 60-to 70 ft. lbs. of torque
55 to 60 foot pounds.
60 foot pounds
60 ( ft. lbs )
The 1998 GMC Jimmy front axle shaft torque specification is 60 pounds. You want to make sure that you do not over torque the axle shaft, as you can ruin the axle bearing.
Can i have the clutch pressure plate bolt torque setting not the FLYWHEEL BOLT
AnswerIf this is the V-6, then you must have a common problem...lower intake leaks coolant.The torque spec for the lower manifold is:First pass: 60 inch poundsSecond pass: 110 inch poundsLast (outer bolts only): 18 foot poundsUpper intake is a total 88 inch pounds in at least two steps.Randy
Tighten the bolts to 60 nM (44 ft. lbs.) in sequence. Tighten the bolts to 60 nM (44 ft. lbs.) in sequence.
Crankshaft to flexplate: 50-60 lb-ft Flexplate to torque converter: 45 lb-ft Use Grade 8 or better at both locations.
Tighten to 50 ft/lb,then back off all rocker shafts,then 22ft/lb plus 60 degrees which is one flat of a bolt "hexagon"