On most vehicles the valve clearance (lash) can be found on the hood decal. The spark plug gap can be found there as well.
On the 2001 Honda Civic, the intake valves should be set within the tolerances of .007"-.009" and the exhaust valve clearance should be set within the tolerances of .009"-.011". First you set the engine to top dead center by rotating the crankshaft pulley so the white marker dot is lined up with the timing mark on the engine. Now look for the camshaft pulley where it has the word "up" written on it. The word "up" should be in the straight up position when checking the number 1 piston's valve clearances. Then rotate the crankshaft 180 degrees and the camshaft will turn 90 degrees. The "up" will be facing the 9 o'clock piston and you can then check the number 3 piston's valve clearances. Rotate the crankshaft another 180 degrees and the camshaft will turn 90 degrees again. You can now check the number 4 piston's valve clearances. Rotate the crankshaft one more time 180 degrees and the camshaft will turn 90 degrees again. You can now make the final adjustments on the number 2 piston's valve clearances.
The piston sequence runs 1-2-3-4 from the driver side (where the belts are) toward the passenger side.
Just wanted to ask if anyone knows the valve clearance specs. For a 91 civic hatchback DX model. Thank you.
.0002in or .05mm intake and exhaust
.006 on intake, .008 on exhaust
0.15 MM or 0.006 IN, intake and exhaust both the same
The valve clearance for this bike is .002" or .05 mm for the intake and exhaust valves. Some people prefer .003" for the exhaust valve.
what is the fuel tank capacity of 1999 honda civic
What is the head torque specs on a 1997 Honda CRV
Straight out of the original 1978 Manual: Intake Valve Clearance - Cold: 0.18mm or 0.007" Intake Valve Clearance - Hot: 0.20mm or 0.008" Exhaust Valve Clearance - Cold: 0.30mm or 0.012" Exhaust Valve Clearance - Hot: 0.33mm or 0.013" The manual states these specs are not the same for the 2T-G motor, only the 2T-C
as far as I've known there is no torque specs for a valve cover ive been workin on Honda's since i was 15 i just have tightend them down tight an there was never any problems
torque head ingine honda civic 03
Found on another web site that the clearance is; Intake- 0.006 in., exhaust- 0.006 in. Settings are taken cold.
what r the torque specs on the plate covering connecting rods on a 2000 honda civic 1.6?