Want this question answered?
It is important to have a diagram when making any changes to a car. A diagram for an Acura Integra's vacuum hoses can be found in the cars maintenance manual.
The water pump on a 1994 Acura Integra is replaced by removing the engine accessories, pulling the radiator hoses, and taking out the retaining bolts. The pump can then be pulled from the engine block, the surface cleaned, and a new pump put in case.
Next to the firewall on the passenger side of the car. Should be black with two hoses comming off of the top.
possibly your hoses. Washer fluid will deteriorate your hoses. Check into that.
I don't know about just the engine but the complete cooling system including the engine , radiator, heater and all hoses holds aprox 5 qts. Some with standard transmission take a little less.
They are just vent hoses for the distributor and they hide under the fuel rail cover.
if its an automatic transmission theres a dipstick on top of the transmission, look above it. It will be to the right of the battery behind some hoses and have a yellow handle.If its a manual (5 speed) there is no disptick.... theres a 17mm bolt (metric thread) that can be removed from the bottom on the transmission. Its on the passenger side.
I've changed it on 94 integra 4 door 3 times, im about to change it on a 95 2 door and it has a tighter compartment. their are 3 screws holding it in 1 on top and 2 deep under the unit itself its best to use extensions to hook up to it after removing radiator hoses and other wires out of the way. will keep ya posted. if you find this too difficult just take it to a mechanic. lol
it on the passenger side up front but its under hoses so you have too move around and through it shaped like a c or u and its yellow or orange depend on your year but you need a long skinny funnel because it has to be poured where you take the dip stick out of its not like the oil where you have to take a top off.... I hope this helped you
This specification is for hydraulic hoses and the various part numbers describe the construction of the hose including material and how many layers of what kind of reinforcement.
The 2.5 Acura has several parts that make up the AC system. The compressor, condenser, cooling radiator, and the inside of the cab core along with the hoses and freon all make up the cooling system.
In the fuel tank only way to get to it is drop the tank it has 2 nuts that need to be undone then all the hoses and drop the tank down then there's 6 screws to undo then take pump out