Want this question answered?
When the curent Is in the secundary for the highervalues Ip in the primary coil are not equal proportional than for the lower curent. Is/Ip for lower values is for exemple 100 Is/Ip for higher values are for exemple 70The reason is the magnetique flux saturation in the closed iron core.Roger
Generally accuracy at low current values isn't important for protective functions. The burden is taken into account when looking at the saturation curve and available short circuit current to insure the CT doesn't saturate during fault conditions.
Highly positive
current in series depends on values of resistors. more resistance less current will flow through and viceversa
Crystal diode for a p-type semiconductor and n-type semiconductor formation of the pn junction, in its interface on both sides of a space-charge layer, and has a self-built electric field. When there is no applied voltage, as pn junction on both sides of carrier concentration caused by the proliferation of poor self-built electric current and drift arising from the current equivalent and the balance of power in the state. When the outside world a positive bias voltage, electric and outside the field of mutual self-suppression role of the Consumers carrier increase from the current spread of the forward current. When the outside world a reverse bias voltage, external electric field and to further strengthen self-built electric field, in a certain form of reverse voltage and reverse bias voltage value unrelated to reverse saturated current I0. When the reverse voltage applied to a certain high level, pn junction in the space charge of the electric field strength to achieve the critical values of the double-carrier process, a large amount of electronic hole right, had a great numerical breakdown of the reverse current, Breakdown phenomenon known as diodes.
When the curent Is in the secundary for the highervalues Ip in the primary coil are not equal proportional than for the lower curent. Is/Ip for lower values is for exemple 100 Is/Ip for higher values are for exemple 70The reason is the magnetique flux saturation in the closed iron core.Roger
because the current push to the junction.
Generally accuracy at low current values isn't important for protective functions. The burden is taken into account when looking at the saturation curve and available short circuit current to insure the CT doesn't saturate during fault conditions.
CB gives a current gain of beta/(beta+1), which with typical beta values is just under one. Note that this current gain value is also known as alpha.
The value that is not typical of most other values in a data set is an Outlier.
Highly positive
What is the significance of negative values of voltage and current?Negative values show direction and that is the significance
typical milk COD = 170000 - 218000 mg/L
The temperature and pressure of the atmosphere must be at that point or in an interval of values for the substance to be saturated. When mixing solutions, the temperature and pressure must be within a certain range for the substance to dissolve.
Starcraft II
Hancock audiences
compared