It depends on the duct system. Each furnace has a recommended outlet temperature. To get the proper airflow for that temperature the duct system has to be properly designed. If properly designed the speed would typically be low.
Forced air heating
This operation requires a licensed electrician. Not recommended to a DIYer.
It could have any size heating furnace, the two are unrelated except for the size blower used in the furnace to support the 3 ton cooling system. But the fact remains you can get a 3 ton blower in 50,000 btu furnace, a 100,00 btu furnace and anything in between.
It depends on the rating of the furnace. There should be a plate or sticker somewhere on the furnace that shows the rating. If you are just powering a blower motor the rating will be lower than if you have an electric heating element.
You can order a replacement motor through a local HVAC supply company in your area. You can also contact the furnace manufacturer about a recommended source for parts. You can order online, too: www.midwesthvacparts.com
Watts
no
Yes it is. It contains the blower.
To add the sae 10 non detergent oil to your furnace blower motor you will have to open the motor section.
Yes, It`s on the inside of the blower compartment cover panel.
Closed loop: 1. Thermostat --> furnace (constant temperature) 2. Toaster setting (light/dark) --> toast (IF the toaster has heat sensors) 3. Refrigerator cold/hot setting --> refrigerator inside temperature (constant) 4. Temperature setting for oven (not stovetop) --> oven temperature constant 5. Clothes dryer with moisture sensor 6. Washing machine water level Furnace. Temperature sensors control when furnace is turned on. Heating sensors in furnace control when air blower is turned on, and when flames must be turned off. Refrigerator. Temperature sensors control when refrigerant cycle turns on and off. Many TV functions, internal operation of disc playback and record, really ad infinitum.
Furnace blower motors are easily found at HVAC installers and repair centers. However, without proper knowledge, a customer should not try to fix this, it can be dangerous.