Hi, I do know that the clutch master servo draws off brake fluid from the brake master cylinder and may require a certified mechanic to replace or rebuild the servo depending on it's condition and cause.
No. Replacement is necessary.
Faulty Clutch Master cylinder.
Most likely it is the slave cylinder on the transmission. you need to check clutch cylander for leaks only place it can leak is the clutch cylander or the fluid line
on the ground, if it tranny leaks
Slave cylinder needs to be replaced.it leaks
Yes you can use brake fluid in the hydraaulic clutch system the cover on the reservoir should be marked dot 3 brake fluid also check for leaks at slave cylinder at bellhousing.
A clutch not disengaging is usually a hydraulic issue. Check your clutch fluid. Then check your clutch master and slave cylinders for leaks.
check your clutch fluid level and your clutch slave cylinder for leaks,if both are ok,then you probly need a new clutch.
look at your clutch master cylinder and check fluid, if low ,check your slave cylinder for leaks ,its bolted on your transmission with 2 bolts ,its at where the boot is ,if leaking ,then replace ,if not then u will need anew clutch.
When fluid leaks out the back side where the plunger goes in, it is going out. Fluid would be seen from inside the cab, up above the clutch pedal.
There are two normal causes. The clutch is worn out or there is a leak in the hydraulic clutch slave or master cylinder. To check the clutch, press the clutch slave cylinder down. If the clutch slave cylinder bellows compresses down to the slave cylinder, the clutch is worn out. Check the clutch master cylinder fluid level. if this is low, then the clutch cylinder need to be checked. To check for a hydraulic leak in the clutch slave cylinder, remove the cylinder's bellows and check for any fluid. If fluid is present, rebuild or replace the cylinder and bleed the system. To check the clutch master cylinder, check the back the of clutch master cylinder for leaks. If fluid is present, replace or rebuild clutch master cylinder and bleed the system. In my experience, hydraulic leaks occur at the clutch slave cylinder.
Go to the transmission and check slave cylinder for leaks,also check clutch master cylinder,then go look by your clutch pedal to see if its leaking there,these are your places that it could be leaking,is your fluid level low,if not ,then you may need a new clutch kit.