0
What can be wrong with a 1985 Toyota Tercel if the cooling fan does not run so the car overheats at stop signs and you have already checked the fuses?
Wiki User
∙ 18y ago
Thermal relay or fan motor itself may be bad. Apply 12 volts directly to the fan motor. If it runs ok, look at the thermal relay.
Wiki User
∙ 18y ago
Add your answer:
Earn +20 pts
How do you read a transmission dipstick on a 1995 Toyota Tercel?
there is no dipstick! it is a sealed unit and has to be put on a lift to have it checked!
Where is the cam shaft position sensor located on a 1996 Tercel?
the last time i checked it was what connected the pistons together and made it run
Why would the temperature go up and down on a 1990 Toyota Tercel especially when stopped at red lights?
Your cooling system needs to be checked out. Your car is obviously overheating. If you leave it stopped at a light too long, chances are you will totally screw your engine. Could be a radiator, water pump, the coolant, or something more serious. Find a mechanic or a friend who knows his stuff.
What might cause a 1988 Tercel to vibrate when stopped at a stop sign or traffic light?
Hey Ben==Have the engine tuned up and have the motor and trans supports checked. GoodluckJoe
How do you adjust the clutch on a 96 Toyota Tercel?
tercel
When was Toyota Tercel created?
Toyota Tercel was created in 1978.
How do you disconnect the alarm system on a 1995 Toyota Tercel?
How disconect the alarm tercel 95
How do you replace serpentine belt on 1995 tercel?
i have a 99 tercel, help?
Thermostat location on 1996 tercel?
Thermostat location on 1996 tercel?
How are the vacuum lines connected to the carb on a 1989 Toyota Tercel?
1989 Tercel does not have a carburetor, it is Fuel Injected. Wrong. My 1989 Tercel has a carb.
A male falcon is called what?
A male falcon is called a tercel, terzel, or tiercel.Horse Isle Quiz Answer: tercel
1996 tercel brake lights turn off?
This could be caused by a malfunctioning fuse. fuses will need to be checked. the light bulbs within the tail lights wil need to be checked. the switch under the brake pedal will need to be check to make sure it it activating properly. if all else fails it could be a wire problem and your wire system will need to be checked
