0
What can cause the turn signals on your 2001 Leganza to stop working suddenly even though you have replaced a burned out fuse and they still won't work?
Wiki User
∙ 14y ago
There are two relays under the drivers side dash. If you look under the dash you will see a green relay next to a gray relay. The green is your turn signal flasher, the gray is for hazards, you need to have both working. If they are working, you can hear them clicking on and off.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What are the reasons other than fuses and bad bulbs for brake lights not working on Daewoo Leganza?
I just had my Daewoo Leganza brake light switch replaced. It goes under the brake pedal. and now my brake lights work fine.
Why are Hazards working but indicators not flashing on Audi tt?
It contains two relays, one for hazard lights and the other for turn signals. The one for the turn signals is defective and must be replaced.
Why are your brake lights and hazard lights not working on a 99 Chevy turn signals and top brake light is working fine?
turn signal switch needs replaced!
I replaced the flasher and my turn signals still don't work on my 1999 Mercury Cougar?
If you replaced the flasher on your 1999 Mercury Cougar and your turn signals are still not working, you should check the turn signal fuse. This fuse is located under the dashboard on the driver's side of the vehicle to the left of the steering column.
Why have your turn signals died on your 1991 Pontiac Firebird?
Turn signals just quit working- have replaced flasher- checked all bulbs and fuses, checked all obvious wires, cleaned grounds, replaced the turn signal switch (that was an adventure). At a loss- any help out there? Hazards work fine- all other lights work fine- turn signals dead
Just replaced multifunction switch in 1998 Lincoln navigator because turn signals were not working Turn signal still not working What is the problem?
Did you happen to check the turn signal flasher before you installed the switch?
Why would the internal heating of a 2001 deawoo leganza not be working even thought the engine thermostat has been replaced and the systme has been bled?
It's probably not getting heated coolant to the radiator. Check the heater control valve and the control on the dasboard.
Turn signals stopped working on 1995 GMC Sonoma fuses good and replaced flasher what is wrong?
Check the ground wire for your lights, located on the frame somewhere Lisa
Turn signals on subaru impreza have stopped working checked all fuse plus relays .can anyone help cheers?
check if reverse lights are working, if not replace the reverse switch plug located underside near the gear box, centre of car, there are two plugs, check if wires are frayed, this happened to me and when I replaced this my turn signals started working. hope this helps
Why would the turn signals quit working when the hazard lights still work and the flasher and bulbs have been replaced on a 1995 Chevrolet Corsica?
Check the flasher for the turn signals which is under the dash on the left side of the steering column . It is different from the emergency flasher.
93 skylark 3.3L . The turn signals suddenly stoped working. before they stopped for a few days they would blink really fast. I do have my hazard lights. The fuses are good. Replaced the Turn signal?
Could just be bad bulbs. When the bulbs go bad, even if only one side of a two lighted bulb, they blink fast. That or the flasher relay.
Why would the odometer stop working In a 2000 Daewoo Leganza?
I don't know I'm very, very sorry!
