On the left side of the Steering Wheel
The flasher for the turn signals is located on what Chevrolet calls the convenience center. It is located behind the dash to the left of the steering column. It is anything but convenient to get to.
If you replaced the flasher on your 1999 Mercury Cougar and your turn signals are still not working, you should check the turn signal fuse. This fuse is located under the dashboard on the driver's side of the vehicle to the left of the steering column.
I may be slightly off, but I have noticed the 'click' for the flasher is coming from the hazzard flasher button. I have removed the harness and found the turn signals do not work as long as the switch is disconnected. Hope this helps!! Just replaced mine. The Emergency Flasher switch (button) on the dashboard serves as the turn signal flasher also. Around a $35.00 item. You have to disassemble the face of the dashboard.. relatively easy, about 45 minutes.
You di dnot mention the kind of car. Most cars have a turn signal flasher and an emergency flasher.Are you sure that you replaced the right one?
you need a new flasher, just go to the local suto store and ask them if they have a new flasher for your turn signals
There are two relays, one for the emergency flasher and one for the turn signals. Replace the Flasher Relay for the turn signals, it is defective.
go to autozone or other auto supply store and ask for a "flasher" for your year make and model. i just hate this problem on my 94 corsica.
The flasher is actually the hazard switch itself. If removed turn signals will not function. Just pop the old switch out and unplug it to replace if broken (if present and signal don't work).
Check fuse Check bulbs--they are double filamented with the smaller for turn signals Replace turn signal flasher--Most common problem
Some vehicles has a flasher relay for the turn signals and another one for the hazard lights. Are you sure you replaced the correct one?
The flasher is a type of switch that regulates the turning on and off of your vehicle's turn signals and hazard signals.
Flasher and fuse
on the Chevy beretta there are 2 flashers one is right next to the steering column to the behind the plastic dash piece,this is your turn signal flasher replace it and your signals should work.
Turn signal flasher?
It is possible if the flasher relay is going out or has gone bad.
If your hazard lights don't work but your turn signals do work it could be that your Hazard Lamp Flasher needs to be replaced. Your car has both a "hazard lamp flasher" and a "turn signal lamp flasher". Your "turn signal lamp flasher" is working but your "Hazard Lamp Flasher" may not be working. Buy a new "hazard lamp flasher" and install it. The hazard lamp flasher is located behind the instrument panel to the left of the steering column.
replace your flasher relay
Replace the Flasher Relay.
you might have a bad Flasher relay.
I just had the same problem and found that my rear turn light bulb went out and the turn signals no longer worked. Check any of the turning bulbs. You may have replaced the hazerd light flasher. There are two flashers, the turn signal one is near the hazerd one under the dash.
it is either bad signal flasher or bad signal switch assembly try another flasher, swap the hazards one in place of the signals one if the hazards work right now if the hazrds dont work either then it is most likely worn switch assembly(common problem in these cars) i am working on a corsica right now that has no brake lights except the third one and it is the switch assembly worn out in it, flashers are good in it
I had the same problem in my 1999 Mercury Cougar, I replaced the flasher located in the blinker assembly. It was very simple to do. Flasher cost about $10
The 1990 VW Jetta turn signals will not work when the ground wire is broken or corroded. The turn signals may need the lightbulb's replaced.
Integrated with the hazard flasher switch (which is in the dash)