USUALLY, when one signal is slower than the other, it's an indication that one of the bulbs, rear or front, is burned out. Without starting the car, turn the key to the "on" position, turn the left signal on and walk around the car and check all the bulbs on that side. Do the same to the right side. I bet you will find at least one bulb that is out. Good Luck! <<<adr>>>
Incorrect size bulb installed.
the turn signal switch sends current to the turn signal flasher. it then goes to the bulb. The turn signal switch will turn on the turn signal and when the brake is applied it cancels out the brake light as it is a duel element bulb. 1 element is for brake and turn and the other is for parking lights. you can not have a blinker and a constant feed to the same element of the bulb at the same time.
The turn signal/hazard light relay is directly behind the fuse box. its about an 1 1/2" wide and about 2" long and its black.
Just above the brake pedal where the capet meets the firewall. There will be 2... 1 for the Hazards and one for the turn signal.
Turn signal switch has 1 hot wire per ea. side.
check and make sure u changed turn signal falsher. there are 2, 1 for turn ,and 1 for hazards. other than that, it sounds like your turn signal switch is broken
you have to go inside engine compartment to the front right side,then reach in and disconnect signal/parking bulb holder electrical connector.Then rotate the turn signal bulb holder 1/4 turn COUNTERCLOCKWISE to remove it.
To turn on the fog lights you pull the end of the turn signal lever it will pop out about 1/8th inch.
Approximately 1 block away from the desired turn
you take the assemble out push the bulb in and turn it 1/4 turn counter clock wise and pull it out to put i back in turn it 1/4 turn clock wise
1] stop or slow down. 2] turn. 3] speed up.
there are two signal lights 1) the signal indicator, which is located by the head lights. 2) the cornering light. 1) is located right next to the head light in the same mounting bracket, there is a total of 3 ports. 1) for high beam 2) low beam 3) turn signal. can be a tight squeeze, you may want to remove the air filter box. good luck.