0
The relay is bad. When you start it the relay is bypassed when the oil preasure gets over 4 pounds. Replace the relay
will probably be a fuel pump going out. fuel pressure is critcal in a CFI unit. it must have at least 58 psi to start...56 psi= no start
Add your answer:
Earn +20 pts
What transmission fluid do you use on Oldsmobile 2000 Bravada?
The 2000 Olds Bravada uses Dextron iv automatic transmission fluid. The fluid is specific and other types should not be substituted.
What is the transmission fluid capacity for a 98 bravada?
When changing the transmission fluid and filter of a car, it is best to know how much transmission fluid goes back into the car. The 1998 Bravada takes close to 12 quarts of transmission fluid to fill.
Where do i add transmission fluid in a 1997 Oldsmobile bravada?
trans fluid goes right in tube used to check fluid level
What causes the steering wheel to jerk when starting a turn from stopped position?
Low Power Steering Fluid
Why does your 99 Bravada shift unecessarily at highway speeds?
you might be having an unsteady foot. or your fluid is low causing slippage.
Where does starter fluid go in a 1999 chrysler 300m?
The use of starting fluid should not be required, and is not recommended.The use of starting fluid should not be required, and is not recommended.
What causes a fluid pocket on the back near the spine?
Fluid.
What do you fill a zippo with?
any lighter fluid, except for bic lighter fluid
How water in brake fluid causes a loss of braking force?
The water will boil when the fluid gets hot. Steam in the fluid will causes a loss of hydraulic pressure.
Extracellular fluid is found everywhere in the body EXCEPT?
Extracellular fluid is found everywhere in the body except in interstitial fluid. Extracellular is outside of cells, and intracellular is inside, therefore it would not be inside cells.
What are the causes of foamy transmission fluid in a 2004 Ram with cummins diesel?
Fluid is overfull, or there is water in the fluid.
What causes the pressure exeted by a fluid?
The weight of the fluid. Pressure = force / area.
