replace rear window wiper motor on 2001 Chevy venture
The wiper motor on a 1998 Chevy Venture is up under the vents next to the windshield. It is bolted to the firewall.
The motor is located on the passenger side firewall.
What is the easiest way to replace the starter motor on a 2000 chev Venture?
Yes, those GM 3400 motors are the same. The transmissions are different -- 4L60e versus a 4L65e
It is on the front of the motor, it will be the bottom most pully.
The most likely cause of a ticking sound in a motor is a bad timing belt. A valve out of time can also cause a ticking sound.
4.5 qts including what's in the oil filter
its on the left side front of the motor next to frame of the van
I had this problem with my 2001 Venture, the dealer replaced the motor and the mechanism. The van was only 6 mos. old..
all you have to do is unplug the motor and the motor is locted under neath the automatic door. and then you can open the door.
Your valves need adjustment. Take it to your preferred mechanic.
look for a shorted electric motor like window motor. when the motor contacts fail they can cause the "ticking" and it drains the power constantly, even when the ignition is off.
Starting the motor.
not without a tow dolly or installing one of those axle quick disconnects
I've got a better question, why is this question in the Chevy venture forum ?
near of blower fan on right side inside the car under dash
if you dont have any oil in the cars motor that would be a reasin why its knocking
Replace the wiper motor with a NEW one (do not use a rebuilt!)
Some of their mounts are, for example the Chevy Venture minivan uses hydraulic filled mounts.
On my 97 it is in side the backdoor just under where it goes through the glass.
Access below glove box Remove wiring harness Remove 3-4 small 5/32? bolts Remove heater motor
Check the throttle position sensor or the idle control motor
I would try the window switch first , but if you are going to replace the switch then you will see how to replace the motor. You would have to take the door panel apart after that its easy.