Car Stereos and Speakers
Radio

What do you do if you took your fuse out and now have no radio and the display says safe?

151617

Top Answer
User Avatar
Wiki User
2005-11-16 22:05:35
2005-11-16 22:05:35

some vehicles have loc features on the stereos, if you do not lock it out properly then you need to go to a dealer to have it rest . theft prevention

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

How do you fix a ford radio that des plays tele

User Avatar

i have brought a car but the radio is showing safe mode and unfortunately i do not have a code are you able to supply the code radio is blaupunk 300 car is a vauxhall zafira 2002

User Avatar

My Manual is for a 04 and its says its under the dash on the drivers side second fuse down also for the cig,radio, power mirrors. Regards HHH

User Avatar

The interior fuse box: There are two fuses, The first is the one that says "Radio" 5amp and the second is one labeled "Chime" for some reason both seem to control the power to the radio.

User Avatar

there is one under the dash that says radio

User Avatar

Theres a spot that says "Radio" under the steering wheel with the rest of the fuses.

User Avatar

There is a code inside the cover of the folder of books that came with the car and an instruction manual of how to put the code into the car

User Avatar

It's not broken, the power has been disconnected(flat battery, radio removed, blown fuse). Just do as the radio says, turn the key to the auxillary position, switch the radio on, wait 2 hrs and then enter the code.

User Avatar

the power has been disconnected for too long of a time and the security system on your radio was activated. look in your owner's manual for a keycode to unlock it.

User Avatar

All of the fuses are located in your fuse panel under the dash. Try the one that says audio 10 amp.

User Avatar

it depends, it might be a fuse, or you might have to get a new code for it. if its a fuse, take out the back seat, the fuse is in the fuse box, next to the battery. it should have a card that says what each fuse is for. usually its fuse number 5.

User Avatar

IN THE SOUND SYSTEM MANUAL THERE WILL BE A 4 DIGIT CODE FOR YOUR STEREO YOU HAVE TO HOLD SCAN AND MODE AT THE SAME TIME UNTIL 1000 LIGHTS UP(DONT CONTINUE HOLDING) THEN USE STATIONS 1-4 TO INPUT YOUR RADIO CODE ONCE CODE IS SHOWN ON DISPLAY PRESS SCAN AND MODE BUTTONS AGAIN SAFE WILL COME BACK ON RELEASE BUTTONS AND FREQUENCY SHOULD DISPLAY. YOU NEED YOUR RADIO CODE ITS ANTI THEFT DEVICE.

User Avatar

check the one that's says acc. it sometimes the same of the radio or dome liths

User Avatar

Read the owners manual. Turn the key to the on position (not start) with the radio off. Wait 10 seconds. Press the "display" button on the radio and hold for 10 to 12 seconds. the radio display will light up . PRESS "display" and "1" to select functions. display i think is enter . read owners MANUAL. It's really simple. Turn the key on but not to start the engine. Make sure the radio is off and hit the "display" button for a couple of seconds, the big knob on the bottom on the left of your radio until the "settings" display shows. Hit the scan button to the right until "Tire pressure" comes up. Hit # 1 on your radio select buttons until it says "reset". Push the "display" button until you hear a "beep". Press the scan button a couple of times until it says "exit" then press "display". After it "beeps" you're all done. If you had an owners manual why would you ask for help.

User Avatar

It was a trick. The 1999 Manual says it is located on the side of the driver seat base. The real fuse box is under the steering column. The radio fuse is second from the bottom on the left and is 20 Amp.

User Avatar

It's the one that says 'room'. Might have an attacment on it so you can pull it up and leave it there. I've just had to find it too (to reset my radio). I found info that said leave it out for 15minutes to reset the fuse and hopefully the radio too.

User Avatar

AnsOn erugh- the cabrio radio reset. The code is in your sound system manual (part of the larger manual). if you bought your car used, its likely the owner removed the card w/ the code. I've had my code memorized for years. I think you can take your car to VW to get the whole system reconfigured for a new security code if you can't find it. Sorry- and good luck. If the display says "SAFE" reset the radio display as follows: On the radio panel hold the "seek" button down by pushing it on the right. Let go, enter the radio code using the radio station buttons. Hold the "seek" button down again by pushing it to the right. The radio will come back on.

User Avatar

look to the right of the radio for a button that says clock. push it and your display shoulg show "set hour" or something similar. use the radio tuning knob to set the hour. push the button again for minutes and use the tuning to set them. if you have an older van there 2 small/tiny buttons to the right of the radio display screen. use a pen tip to push them. they are marked HH and MM.

User Avatar

Who is it who says "on" on heart

User Avatar

on my 95' explorer if you turn the radio off you can get the clock. also there is usually a button you press for "display" or says "clock".


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.