0
What does it mean if you find excessive burned oil on top of your piston when you go to rebuild a single cylinder two-stroke motocycle engine?
Wiki User
∙ 16y ago
Either over oiling or a 'cold' spark plug. It is difficult to know as two strokes tend toward oily piston tops anyway. Mix-in-tank bikes are susceptible to over oiling, evaporation of the fuel increases the oil/ fuel ratio. Plugs have different temperature ranges. Changing the plug for a hotter one can often reduce fouling and improve performance. As will a properly baffled and clean muffler. Plug and points gaps and timing are critical.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
How hard is it to rebuild a cylinder in a Honda Accord engine?
The best to rebuild a cylinder is to rebore it. If the cylinder looks ok then just a minor hone job is required.
How do I attach the cable from master cylinder to the slave cylinder in a 1993 Ford Ranger?
the master and slave cylinder are a built in unit,there is no cable between them. there are piston'fluid connected. you can buy a rebuild kit for $9.00. But it is much better to buy a rebuilt master cylinder than try to rebuild it. Especially on ABS master cyclinders.
How do you fix wheel cylinder leaking brake fluid?
Rebuild the cylinders on that caliper.
How do you fix excessive oil blow by?
put in new piston rings or rebuild kit for the entire motor
How do you replace the ignition key cylinder in a 2003 Jeep Liberty?
Any decent locksmith can rebuild the lock cylinder it for $25 - $50. DO NOT TAKE IT TO THE DEALERSHIP
Where can I get advice on how to rebuild a hydraulic cylinder?
A good informative website on how to go about reparing a hydraulic cylinder is http://www.associatedcontent.com/article/799413/how_to_rebuild_and_repair_hydraulic.html?cat=59. A good website that offers possible scenarios is http://www.buzzle.com/articles/how-to-rebuild-hydraulic-cylinder.html.
How do you fix the master cylinder on a 93 ford aerostar?
you can buy a rebuild kit at your local parts store but it is usually cheaper to just replace the master cylinder!
How do you fix a clutch master cylinder on 1996 Mazda 626?
the clutch on the 626 is hydrolic like on the mx6 you have two chioces if its the cylinder and not the lines or transmission choice one replace hole cylinder cost 65 dollars plus choice two try to find a rebuild kit cost 15 dollars plus the rebuild kit should have all the enter workings of the cylinder and they are easy to put together
How do you fix a clutch master cylinder leak on a 1990 f-150 302?
If it's leaking out the end of the master cylinder you'll need to replace it. Don't even bother trying to rebuild the clutch master cylinder, it just isn't worth the trouble. You can buy one from most auto parts retailers for about the same price as a rebuild kit, and often for less.
Why would a Chevy 350 have low compression on every cylinder after rebuild?
head gaskets??? warped heads? did you have them milled?
How do you fix a slave cylinder in a 1993 ford ranger?
you just need to hone it out and replace parts with rebuild kit.
How do you rebuild rear brake master cylinder on 1976 harley?
If kit is available - comes with exploded view and instructions
