0
What does it mean when the Check Engine Light stays on the entire time while driving a 1997 Buick LeSabre and hasn't gone off after getting an oil change?
Wiki User
∙ 17y ago
It means the computer has detected a problem with the emissions system. The oil change had nothing to do with it. A loose gas cap can however cause this. Tighten the gas cap 3 clicks. You will need to have the computer scanned with an OBD2 scan tool, to retrieve the code. This code will tell you what part is being effected. Not what part is bad, but which one is being effected.
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
Change a water pump on a 1997 Buick LeSabre V6 engine?
hi my car is leaking from the water pump so what can i do to stop leak ? and if i need to change the water pump would you guys tell me how can i change it?my car is 1997 Buick LeSabre v6 engine
Where is the bolt to change the starter out of a 1987 Buick LeSabre 3.8?
There are 2 bolts that hold it to the rear of the engine.
Why does my car lurch and feels like gas is not getting to the engine while Im driving?
If feels like your car isn't getting gas to the engine, perhaps the fuel injectors are clogged. You may also need to change the fuel filter.
How do you change brake lines on a 1991 Buick lesabre?
How to change brake lines on a 1991 Buick Lesabre?
Is there a change in 3800 engine between lesabre and lucerne?
Exactly the same except the Lucerne has the improved metal manifold pipe. I think the 04 and 05 LeSabre also replaced the plastic pipe with metal.
When to change timing belt on 2001 buick lesabre?
your engine has a timing chain,no rubber belt but after 250k plus the chain wears and should be checked
How do you change the radiator in a 2000 Buick lesabre?
Instructions for replacing radiator on 2000 Buick Lesabre custom
How do you change the flywheel and starter of a 1987 Buick LeSabre?
Get a manual on your car from the parts store or from AUTOBOOKSONLINE.COM. This is not a job for the backyard mechanic as you have to hold the engine while the trans is pulled.
What is the problem when the oil pressure light in 1997 Buick Lesabre with 160000 miles blinks on and off when car is idle it goes out when car being driven?
The engine main and/or rod bearings are worn. Change to a heavier grade oil (higher viscosity number) and the light should stop flickering so much. If you do that you can make the engine last a little longer, but the engine is definitely getting tired.
How do change a drive belt on a 1998 Buick Lesabre if the engine mounts appear to be in the way?
Well if it looks anything like my Skylark, then that motor mount has to come out. Make sure you support the engine with a jack and block of wood when you pull it. I just changed mine on my LeSabre yesterday and that is exactly how I did it. I also removed the right passenger tire for easier access to the motor mount.
Can a Toyota engine still run without having an oil change for a year?
As long as there is oil in the engine it can run. If it has not had an oil change for a year even if it was stored I would change the oil/filter before driving this car.
If you have Hero Honda Splendor 2003 model its engine is getting extremely hot what could be the reason?
change the engine
